Datasheet

 2009 Microchip Technology Inc. DS39897C-page 223
PIC24FJ256GB110 FAMILY
REGISTER 18-4: U1OTGCON: USB ON-THE-GO CONTROL REGISTER
U-0 U-0 U-0 U-0 U-0 U-0 U-0 U-0
— — — — — — — —
bit 15 bit 8
R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0
DPPULUP DMPULUP DPPULDWN
(1)
DMPULDWN
(1)
VBUSON
(1)
OTGEN
(1)
VBUSCHG
(1)
VBUSDIS
(1)
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15-8 Unimplemented: Read as ‘0’
bit 7 DPPULUP: D+ Pull-Up Enable bit
1 = D+ data line pull-up resistor enabled
0 = D+ data line pull-up resistor disabled
bit 6 DMPULUP: D- Pull-Up Enable bit
1 = D- data line pull-up resistor enabled
0 = D- data line pull-up resistor disabled
bit 5 DPPULDWN: D+ Pull-Down Enable bit
(1)
1 = D+ data line pull-down resistor enabled
0 = D+ data line pull-down resistor disabled
bit 4 DMPULDWN: D- Pull-Down Enable bit
(1)
1 = D- data line pull-down resistor enabled
0 = D- data line pull-down resistor disabled
bit 3 VBUSON: V
BUS Power-on bit
(1)
1 =VBUS line powered
0 =V
BUS line not powered
bit 2 OTGEN: OTG Features Enable bit
(1)
1 = USB OTG enabled; all D+/D- pull-ups and pull-downs bits are enabled
0 = USB OTG disabled; D+/D- pull-ups and pull-downs are controlled in hardware by the settings of the
HOSTEN and USBEN bits (U1CON<3,0>)
bit 1 VBUSCHG: V
BUS Charge Select bit
(1)
1 =VBUS line set to charge to 3.3V
0 =V
BUS line set to charge to 5V
bit 0 VBUSDIS: VBUS Discharge Enable bit
(1)
1 =VBUS line discharged through a resistor
0 =V
BUS line not discharged
Note 1: These bits are only used in Host mode; do not use in Device mode.