Datasheet

 2008-2013 Microchip Technology Inc. DS80369P-page 17

PIC24FJ256GB110 FAMILY

4. Module: Electrical Specifications

(DC Characteristics)

Table 29-3 (“DC Characteristics: Temperature

and Voltage Specifications”) is amended by add-

ing a new specification, VUSB, and an explanatory

footnote. The changes are shown below in bold

text (bold text in original was removed for clarity).

5. Module: Electrical Specifications

In Table 29-3 (“DC Characteristics: Temperature

and Voltage Specifications”), the Minimum and

Maximum values for DC18 (BOR Voltage on VDD

Transition) are changed to 1.80V and 2.25V,

respectively. The Typical value remains

unchanged.

TABLE 29-3: DC CHARACTERISTICS: TEMPERATURE AND VOLTAGE SPECIFICATIONS

(PARTIAL REPRESENTATION)

DC CHARACTERISTICS

Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)

Operating temperature -40°C  T

A  +85°C for Industrial

Param

No.

Symbol Characteristic Min Typ

(1)

Max Units Conditions

Operating Voltage

USB USB Supply Voltage 3.0 3.3 3.6 V USB module enabled

(3)

Note 1: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance only

and are not tested.

2: This is the limit to which V

DD can be lowered without losing RAM data.

3: VUSB should always be maintained at VDD or greater when the USB module is enabled. The VUSB pin

may be left in a high-impedance state when the USB module is disabled and pins, RG2 and RG3,

will not be used as general purpose inputs, but doing so may result in higher IPD currents than

specified.