Datasheet

 2010 Microchip Technology Inc. DS39905E-page 277
PIC24FJ256GA110 FAMILY
DC62 2.5 7.0 A -40°C
2.0V
(3)
RTCC + Timer1 w/32 kHz Crystal:
RTCC I
TI32
(5)
DC62a 2.5 7.0 A +25°C
DC62m 3.0 7.0 A +60°C
DC62b 3.0 7.0 A +85°C
DC62j 6.0 12.0 A +125°C
DC62c 2.8 7.0 A -40°C
2.5V
(3)
DC62d 3.0 7.0 A +25°C
DC62n 3.0 7.0 A +60°C
DC62e 3.0 7.0 A +85°C
DC62k 6.0 12.0 A +125°C
DC62f 3.5 10.0 A -40°C
3.3V
(4)
DC62g 3.5 10.0 A +25°C
DC62p 4.0 10.0 A +60°C
DC62h 4.0 10.0 A +85°C
DC62l 8.0 18.0 A +125°C
TABLE 28-6: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD) (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (I
PD): PMD Bits are Set, PMSLP Bit is ‘0’
(2)
Note 1: Data in the Typical column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance only
and are not tested.
2: Base I
PD is measured with all peripherals and clocks shut down. All I/Os are configured as inputs and pulled
high. WDT, etc., are all switched off.
3: On-chip voltage regulator disabled (ENVREG tied to V
SS).
4: On-chip voltage regulator enabled (ENVREG tied to V
DD).
5: The  current is the additional current consumed when the module is enabled. This current should be added to
the base I
PD current.