Datasheet

PIC24FJ256GA110 FAMILY
DS39905E-page 172  2010 Microchip Technology Inc.
REGISTER 14-1: OCxCON1: OUTPUT COMPARE x CONTROL 1 REGISTER
U-0 U-0 R/W-0 R/W-0 R/W-0 R/W-0 U-0 U-0
— — OCSIDL OCTSEL2 OCTSEL1 OCTSEL0 — —
bit 15 bit 8
R/W-0 U-0 U-0 R/W-0, HCS
R/W-0 R/W-0 R/W-0 R/W-0
ENFLT0
— — OCFLT0 TRIGMODE OCM2
(1)
OCM1
(1)
OCM0
(1)
bit 7 bit 0
Legend: HCS = Hardware Clearable/Settable bit
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15-14 Unimplemented: Read as ‘0’
bit 13 OCSIDL: Stop Output Compare x in Idle Mode Control bit
1 = Output Compare x halts in CPU Idle mode
0 = Output Compare x continues to operate in CPU Idle mode
bit 12-10 OCTSEL<2:0>: Output Compare x Timer Select bits
111 = Peripheral Clock (F
CY)
110 = Reserved
101 = Reserved
100 = Timer1
011 = Timer5
010 = Timer4
001 = Timer3
000 = Timer2
bit 9-8 Unimplemented: Read as ‘0’
bit 7 ENFLT0: Fault 0 Input Enable bit
1 = Fault 0 input is enabled
0 = Fault 0 input is disabled
bit 6-5 Unimplemented: Read as ‘0’
bit 4 OCFLT0: PWM Fault Condition Status bit
1 = PWM Fault condition has occurred (cleared in HW only)
0 = No PWM Fault condition has occurred (this bit is only used when OCM<2:0> = 111)
bit 3 TRIGMODE: Trigger Status Mode Select bit
1 = TRIGSTAT (OCxCON2<6>) is cleared when OCxRS = OCxTMR or in software
0 = TRIGSTAT is only cleared by software
bit 2-0 OCM<2:0>: Output Compare x Mode Select bits
(1)
111 = Center-Aligned PWM mode on OCx
(2)
110 = Edge-Aligned PWM mode on OCx
(2)
101 = Double Compare Continuous Pulse mode: initialize OCx pin low, toggle OCx state continuously
on alternate matches of OCxR and OCxRS
100 = Double Compare Single-Shot mode: initialize OCx pin low, toggle OCx state on matches of OCxR
and OCxRS for one cycle
011 = Single Compare Continuous Pulse mode: compare events continuously toggle OCx pin
010 = Single Compare Single-Shot mode: initialize OCx pin high, compare event forces OCx pin low
001 = Single Compare Single-Shot mode: initialize OCx pin low, compare event forces OCx pin high
000 = Output compare channel is disabled
Note 1: The OCx output must also be configured to an available RPn pin. For more information, see Section 10.4
“Peripheral Pin Select”.
2: OCFA pin controls OC1-OC4 channels; OCFB pin controls the OC5-OC9 channels. OCxR and OCxRS are
double-buffered only in PWM modes.