Datasheet

PIC24FJ256DA210 FAMILY
DS39969B-page 260  2010 Microchip Technology Inc.
REGISTER 18-8: U1CON: USB CONTROL REGISTER (HOST MODE ONLY)
U-0 U-0 U-0 U-0 U-0 U-0 U-0 U-0
— — — — — — — —
bit 15 bit 8
R-x, HSC R-x, HSC R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0
JSTATE SE0 TOKBUSY USBRST HOSTEN RESUME PPBRST SOFEN
bit 7 bit 0
Legend: U = Unimplemented bit, read as ‘0’
R = Readable bit W = Writable bit HSC = Hardware Settable/Clearable bit
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15-8 Unimplemented: Read as ‘0’
bit 7 JSTATE: Live Differential Receiver J State Flag bit
1 = J state (differential ‘0’ in low speed, differential ‘1’ in full speed) is detected on the USB
0 = No J state is detected
bit 6 SE0: Live Single-Ended Zero Flag bit
1 = Single-ended zero is active on the USB bus
0 = No single-ended zero is detected
bit 5 TOKBUSY: Token Busy Status bit
1 = Token is being executed by the USB module in On-The-Go state
0 = No token is being executed
bit 4 USBRST: Module Reset bit
1 = USB Reset has been generated; for software Reset, application must set this bit for 50 ms, then
clear it
0 = USB Reset is terminated
bit 3 HOSTEN: Host Mode Enable bit
1 = USB host capability is enabled; pull-downs on D+ and D- are activated in hardware
0 = USB host capability is disabled
bit 2 RESUME: Resume Signaling Enable bit
1 = Resume signaling is activated; software must set bit for 10 ms and then clear to enable remote
wake-up
0 = Resume signaling is disabled
bit 1 PPBRST: Ping-Pong Buffers Reset bit
1 = Reset all Ping-Pong Buffer Pointers to the even BD banks
0 = Ping-Pong Buffer Pointers are not reset
bit 0 SOFEN: Start-Of-Frame Enable bit
1 = Start-Of-Frame token is sent every one 1 ms
0 = Start-Of-Frame token is disabled