Datasheet

© 2011-2012 Microchip Technology Inc. Preliminary DS39997C-page 281
PIC24FJ16MC101/102 AND PIC24FJ32MC101/102/104
FIGURE 26-14: SPIx MASTER MODE (FULL-DUPLEX, CKE = 0, CKP = X, SMP = 1) TIMING
CHARACTERISTICS FOR PIC24FJ16MC101/102
TABLE 26-32: SPIx MASTER MODE (FULL-DUPLEX, CKE = 0, CKP = x, SMP = 1) TIMING
REQUIREMENTS FOR PIC24FJ16MC101/102
AC CHARACTERISTICS
Standard Operating Conditions: 2.4V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C ≤ TA ≤ +125°C for Extended
Param
No.
Symbol Characteristic
(1)
Min Typ
(2)
Max Units Conditions
SP10 TscP Maximum SCK Frequency — — 10 MHz
-40ºC to +125ºC and
see Note 3
SP20 TscF SCKx Output Fall Time — — — ns See parameter DO32
and Note 4
SP21 TscR SCKx Output Rise Time — — — ns See parameter DO31
and Note 4
SP30 TdoF SDOx Data Output Fall Time — — — ns See parameter DO32
and Note 4
SP31 TdoR SDOx Data Output Rise Time — — — ns See parameter DO31
and Note 4
SP35 TscH2doV,
TscL2doV
SDOx Data Output Valid after
SCKx Edge
— 6 20 ns —
SP36 TdoV2scH,
TdoV2scL
SDOx Data Output Setup to
First SCKx Edge
30 — — ns —
SP40 TdiV2scH,
TdiV2scL
Setup Time of SDIx Data
Input to SCKx Edge
30 — — ns —
SP41 TscH2diL,
TscL2diL
Hold Time of SDIx Data Input
to SCKx Edge
30 — — ns —
Note 1: These parameters are characterized, but are not tested in manufacturing.
2: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.
3: The minimum clock period for SCKx is 100 ns. The clock generated in Master mode must not violate this
specification.
4: Assumes 50 pF load on all SPIx pins.
SCKx
(CKP = 0)
SCKx
(CKP = 1)
SDOx
SDIx
SP10
SP40
SP41
SP21
SP20
SP35
SP20
SP21
MSb LSb
Bit 14 - - - - - -1
MSb In
LSb In
Bit 14 - - - -1
SP30, SP31
SP30, SP31
Note: Refer to Figure 26-1 for load conditions.