Information

PIC24FJ256GA110 FAMILY
DS80385B-page 4 © 2009 Microchip Technology Inc.
TABLE 27-6: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for Industrial
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (I
PD)
(2)
DC60 0.1 1.0 μA-40°C
2.0V
(3)
Base Power-Down Current
(5)
DC60a 0.15 1.0 μA+25°C
DC60b 3.7 18.0 μA+85°C
DC60c 0.2 1.4 μA-40°C
2.5V
(3)
DC60d 0.25 1.4 μA+25°C
DC60e 4.2 27.0 μA+85°C
DC60f 3.6 10.0 μA-40°C
3.3V
(4)
DC60g 4.0 10.0 μA+25°C
DC60h 11.0 36.0 μA+85°C
DC61 1.75 3 μA-40°C
2.0V
(3)
Watchdog Timer Current: ΔIWDT
(5)
DC61a 1.75 3 μA+25°C
DC61b 1.75 3 μA+85°C
DC61c 2.4 4 μA-40°C
2.5V
(3)
DC61d 2.4 4 μA+25°C
DC61e 2.4 4 μA+85°C
DC61f 2.8 5 μA-40°C
3.3V
(4)
DC61g 2.8 5 μA+25°C
DC61h 2.8 5 μA+85°C
DC62 2.5 7.0 μA-40°C
2.0V
(3)
RTCC + Timer1 w/32 kHz Crystal:
ΔRTCC + ΔI
TI32
(5)
DC62a 2.5 7.0 μA+25°C
DC62b 3.0 7.0 μA+85°C
DC62c 2.8 7.0 μA-40°C
2.5V
(3)
DC62d 3.0 7.0 μA+25°C
DC62e 3.0 7.0 μA+85°C
DC62f 3.5 10.0 μA-40°C
3.3V
(4)
DC62g 3.5 10.0 μA+25°C
DC62h 4.0 10.0 μA+85°C
Note 1: Data in the Typical column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
PD is measured with all peripherals and clocks shut down. All I/Os are configured as inputs and
pulled high. WDT, etc., are all switched off, and the Peripheral Module Disable (PMD) bits for all unused
peripherals are set.
3: On-chip voltage regulator disabled (ENVREG tied to V
SS).
4: On-chip voltage regulator enabled (ENVREG tied to V
DD), Low-Voltage Detect (LVD) and Brown-out
Detect (BOD) are enabled.
5: The Δ current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.