Information

© 2009 Microchip Technology Inc. DS80385B-page 3
PIC24FJ256GA110 FAMILY
TABLE 27-5: DC CHARACTERISTICS: IDLE CURRENT (IIDLE)
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for Industrial
Parameter
No.
Typical
(1)
Max Units Conditions
Idle Current (I
IDLE)
(2)
DC40 220 310 μA-40°C
2.0V
(3)
1 MIPS
DC40a 220 310 μA+25°C
DC40b 220 310 μA+85°C
DC40d 300 390 μA-40°C
3.3V
(4)
DC40e 300 390 μA+25°C
DC40f 320 420 μA+85°C
DC43 0.85 1.1 mA -40°C
2.0V
(3)
4 MIPS
DC43a 0.85 1.1 mA +25°C
DC43b 0.87 1.2 mA +85°C
DC43d 1.1 1.4 mA -40°C
3.3V
(4)
DC43e 1.1 1.4 mA +25°C
DC43f 1.1 1.4 mA +85°C
DC47 4.4 5.6 mA -40°C
2.5V
(3)
16 MIPS
DC47a 4.4 5.6 mA +25°C
DC47b 4.4 5.6 mA +85°C
DC47c 4.4 5.6 mA -40°C
3.3V
(4)
DC47d 4.4 5.6 mA +25°C
DC47e 4.4 5.6 mA +85°C
DC50 1.1 1.4 mA -40°C
2.0V
(3)
FRC (4 MIPS)
DC50a 1.1 1.4 mA +25°C
DC50b 1.1 1.4 mA +85°C
DC50d 1.4 1.8 mA -40°C
3.3V
(4)
DC50e 1.4 1.8 mA +25°C
DC50f 1.4 1.8 mA +85°C
DC51 4.3 6.0 μA-40°C
2.0V
(3)
LPRC (31 kHz)
DC51a 4.5 6.0 μA+25°C
DC51b 10.0 25 μA+85°C
DC51d 44.0 60.0 μA-40°C
3.3V
(4)
DC51e 44.0 60.0 μA+25°C
DC51f 70.0 115.0 μA+85°C
Note 1: Data in “Typical” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
IDLE current is measured with core off, OSCI driven with external square wave from rail to rail. All
I/O pins are configured as inputs and pulled to V
DD. MCLR = VDD; WDT and FSCM are disabled. No
peripheral modules are operating and all of the Peripheral Module Disable (PMD) bits are set.
3: On-chip voltage regulator disabled (ENVREG tied to V
SS).
4: On-chip voltage regulator enabled (ENVREG tied to V
DD), Low-Voltage Detect (LVD) and Brown-out
Detect (BOD) are enabled.