Datasheet

 2005-2012 Microchip Technology Inc. DS39747F-page 221
PIC24FJ128GA010 FAMILY
TABLE 27-7: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (I
PD)
(2)
DC60 3 25 A-40°C
2.0V
(3)
Base Power-Down Current
(5)
DC60a 3 45 A+25°C
DC60b 100 600 A+85°C
DC60f 20 40 A-40°C
3.6V
(4)
DC60g 27 60 A+25°C
DC60h 120 600 A+85°C
Module Differential Current
DC61 10 25 A-40°C
2.0V
(3)
Watchdog Timer Current: IWDT
(5)
DC61a 10 25 A+25°C
DC61b 10 25 A+85°C
DC61f 10 25 A-40°C
3.6V
(4)
DC61g 10 25 A+25°C
DC61h 10 25 A+85°C
DC62 8 15 A-40°C
2.0V
(3)
RTCC + Timer1 w/32 kHz Crystal:
I
RTCC
(5)
DC62a 8 15 A+25°C
DC62b 8 15 A+85°C
DC62f 8 15 A-40°C
3.6V
(4)
DC62g 8 15 A+25°C
DC62h 8 15 A+85°C
Note 1: Data in the Typical column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
PD is measured with all peripherals and clocks shut down. All I/Os are configured as inputs and
pulled high. WDT, etc., are all switched off. Unused PMD bits are set. VREGS bit is clear.
3: On-chip voltage regulator is disabled (ENVREG tied to V
SS).
4: On-chip voltage regulator is enabled (ENVREG tied to VDD).
5: The  current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.