Datasheet

PIC24FJ128GA010 FAMILY
DS39747F-page 198  2005-2012 Microchip Technology Inc.
REGISTER 24-2: FLASH CONFIGURATION WORD 2
U-1 U-1 U-1 U-1 U-1 U-1 U-1 U-1
— — — — — — — —
bit 23 bit 16
R/PO-1 U-1 U-1 U-1 U-1 R/PO-1 R/PO-1 R/PO-1
IESO
— — — — FNOSC2 FNOSC1 FNOSC0
bit 15 bit 8
R/PO-1 R/PO-1 R/PO-1 U-1 U-1 U-1 R/PO-1 R/PO-1
FCKSM1 FCKSM0 OSCIOFCN
— — — POSCMD1 POSCMD0
bit 7 bit 0
Legend: x = Bit is unknown
R = Readable bit PO = Program Once bit U = Unimplemented bit, read as ‘0’
-n = Value when device is unprogrammed ‘1’ = Bit is set ‘0’ = Bit is cleared
bit 23-16 Unimplemented: Read as ‘1’
bit 15 IESO: Internal External Switchover bit
1 = IESO mode (Two-Speed Start-up) is enabled
0 = IESO mode (Two-Speed Start-up) is disabled
bit 14-11 Unimplemented: Read as ‘1’
bit 10-8 FNOSC<2:0>: Initial Oscillator Select bits
111 = Fast RC Oscillator with Postscaler (FRCDIV)
110 = Reserved
101 = Low-Power RC Oscillator (LPRC)
100 = Secondary Oscillator (SOSC)
011 = Primary Oscillator with PLL module (XTPLL, HSPLL, ECPLL)
010 = Primary Oscillator (XT, HS, EC)
001 = Fast RC Oscillator with postscaler and PLL module (FRCPLL)
000 = Fast RC Oscillator (FRC)
bit 7-6 FCKSM<1:0>: Clock Switching and Fail-Safe Clock Monitor Configuration bits
1x = Clock switching and Fail-Safe Clock Monitor are disabled
01 = Clock switching is enabled, Fail-Safe Clock Monitor is disabled
00 = Clock switching is enabled, Fail-Safe Clock Monitor is enabled
bit 5 OSCIOFCN: OSC2 Pin Configuration bit
If POSCMD<1:0> =
11 or 00:
1 = OSC2/CLKO/RC15 functions as CLKO (FOSC/2)
0 = OSC2/CLKO/RC15 functions as port I/O (RC15)
If POSCMD<1:0> =
10 or 01:
OSCIOFCN has no effect on OSC2/CLKO/RC15.
bit 4-2 Unimplemented: Read as ‘1’
bit 1-0 POSCMD<1:0>: Primary Oscillator Configuration bits
11 = Primary oscillator is disabled
10 = HS Oscillator mode is selected
01 = XT Oscillator mode is selected
00 = EC Oscillator mode is selected