Datasheet

PIC24FJ128GA010 FAMILY
DS39747F-page 128  2005-2012 Microchip Technology Inc.
To set up the SPI module for the Enhanced Buffer
Master mode of operation:
1. If using interrupts:
a) Clear the SPIxIF bit in the respective IFSx
register.
b) Set the SPIxIE bit in the respective IECx
register.
c) Write the SPIxIP bits in the respective IPCx
register.
2. Write the desired settings to the SPIxCON1
and SPIxCON2 registers with MSTEN
(SPIxCON1<5>) = 1.
3. Clear the SPIROV bit (SPIxSTAT<6>).
4. Select Enhanced Buffer mode by setting the
SPIBEN bit (SPIxCON2<0>).
5. Enable SPI operation by setting the SPIEN bit
(SPIxSTAT<15>).
6. Write the data to be transmitted to the SPIxBUF
register. Transmission (and reception) will start
as soon as data is written to the SPIxBUF
register.
To set up the SPI module for the Enhanced Buffer
Slave mode of operation:
1. Clear the SPIxBUF register.
2. If using interrupts:
• Clear the SPIxIF bit in the respective IFSx
register.
• Set the SPIxIE bit in the respective IECx
register.
• Write the SPIxIP bits in the respective IPCx
register to set the interrupt priority.
3. Write the desired settings to the SPIxCON1
and SPIxCON2 registers with MSTEN
(SPIxCON1<5>) = 0.
4. Clear the SMP bit.
5. If the CKE bit is set, then the SSEN bit must be
set, thus enabling the SSx
pin.
6. Clear the SPIROV bit (SPIxSTAT<6>).
7. Select Enhanced Buffer mode by setting the
SPIBEN bit (SPIxCON2<0>).
8. Enable SPI operation by setting the SPIEN bit
(SPIxSTAT<15>).
FIGURE 15-1: SPIx MODULE BLOCK DIAGRAM (STANDARD MODE)
Internal Data Bus
SDIx
SDOx
SSx
/FSYNCx
SCKx
SPIxSR
bit 0
Shift
Control
Edge
Select
F
CY
Primary
1:1/4/16/64
Enable
Prescaler
Sync
Clock
Control
SPIxBUF
Control
TransferTransfer
Write SPIxBUFRead SPIxBUF
16
SPIxCON1<1:0>
SPIxCON1<4:2>
Master Clock
Secondary
Prescaler
1:1 to 1:8