Datasheet

PIC24FJ256DA210 FAMILY
DS39969B-page 376  2010 Microchip Technology Inc.
TABLE 30-6: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.2V to 3.6V (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (I
PD)
(2)
DC60D 20.0 45 A-40°C
3.3V
(3)
Base power-down current
(4)
DC60E 20.0 45 A+25°C
DC60H 55.0 105 A+60°C
DC60F 95.0 185 A+85°C
DC61D 1.0 3.5 A-40°C
3.3V
(3)
31 kHz LPRC oscillator with
RTCC, WDT or Timer1:I
LPRC
(4)
DC61E 1.0 3.5 A+25°C
DC61H 1.0 3.5 A+60°C
DC61F 2.5 6.5 A+85°C
DC62D 1.5 6 A-40°C
3.3V
(3)
Low drive strength, 32 kHz crystal
with RTCC or Timer1: I
SOSC;
SOSCSEL<1:0> = 01
(4)
DC62E 1.5 6 A+25°C
DC62H 1.5 6 A+60°C
DC62F 8.0 18 A+85°C
DC63D 4.0 18 A-40°C
3.3V
(3)
32 kHz crystal
with RTCC or Timer1: I
SOSC;
SOSCSEL<1:0> = 11
(4)
DC63E 4.0 18 A+25°C
DC63H 6.5 18 A+60°C
DC63F 12.0 25 A+85°C
Note 1: Data in the Typical column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
PD is measured with the device in Sleep mode (all peripherals and clocks are shut down). All I/Os
are configured as inputs and pulled high. WDT, etc., are all switched off, PMSLP bit is clear and the
Peripheral Module Disable (PMD) bits for all unused peripherals are set.
3: On-chip voltage regulator enabled (ENVREG tied to VDD). Brown-out Reset (BOR) is enabled.
4: The  current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.