Datasheet

 2010 Microchip Technology Inc. DS39969B-page 3
PIC24FJ256DA210 FAMILY
Graphics Controller Features:
• Three Graphics Hardware Accelerators to Facilitate
Rendering of Block Copying, Text and Unpacking of
Compressed Data
• Color Look-up Table (CLUT) with Maximum of 256 Entries
• 1/2/4/8/16 bits-per-pixel (bpp) Color Depth Set at
Run Time
• Display Resolution Programmable According to
Frame Buffer:
- Supports direct access to external memory on
devices with EPM
P
- Resolution supported is up to 480x272 @ 60 Hz,
16 bpp; 640x480 @ 30 Hz, 16 bpp or
640x480 @ 60 Hz, 8 bpp
• Supports Various Display Interfaces:
- 4/8/16-bit Monochrome STN
- 4/8/16-bit Color STN
- 9/12/18/24-bit Color TFT (18 and 24-bit displays
are connected as 16-bit, 5-6-5 RGB color format)
Universal Serial Bus Features:
• USB v2.0 On-The-Go (OTG) Compliant
• Dual Role Capable – Can act as either Host or Peripheral
• Low-Speed (1.5 Mbps) and Full-Speed (12 Mbps)
USB Operation in Host mode
• Full-Speed USB Operation in Device mode
• High-Precision PLL for USB
• Supports up to 32 Endpoints (16 bidirectional):
- USB module can use the internal RAM location
from 0x800 to 0xFFFF as USB endpoint buffers
• On-Chip USB Transceiver with Interface for Off-Chip
Transceiver
• Supports Control, Interrupt, Isochronous and Bulk
Transfers
• On-Chip Pull-up and Pull-Down Resistors
Peripheral Features:
• Enhanced Parallel Master Port/Parallel Slave Port
(EPMP/PSP), 100-pin devices only:
- Direct access from CPU with an Extended Data
Space (EDS) interface
- 4, 8 and 16-bit wide data bus
- Up to 23 programmable address lines
- Up to 2 chip select lines
- Up to 2 Acknowledgement lines (one per chip
select)
- Programmable address/data multiplexing
- Programmable address and data Wait states
- Programmable polarity on control signals
• Peripheral Pin Select:
- Up to 44 available pins (100-pin devices)
• Three 3-Wire/4-Wire SPI modules (supports 4 Frame
modes)
•Three I
2
C™ modules Supporting Multi-Master/Slave
modes and 7-Bit/10-Bit Addressing
•Four UART modules:
- Supports RS-485, RS-232, LIN/J2602 protocols
and IrDA
®
• Five 16-Bit Timers/Counters with Programmable
Prescaler
• Nine 16-Bit Capture Inputs, each with a Dedicated Time
Base
• Nine 16-Bit Compare/PWM Outputs, each with a Dedi-
cated Time Base
• Hardware Real-Time Clock and Calendar (RTCC)
• Enhanced Programmable Cyclic Redundancy Check
(CRC) Generator
• Up to 5 External Interrupt Sources
PIC24FJ Device
Pins
Program Memory
(bytes)
SRAM (bytes)
Remappable Peripherals
I
2
C™
10-Bit A/D (ch)
Comparators
CTMU
EPMP/PSP
RTCC
Graphics Controller
USB OTG
Remappable
Pins
16-Bit Timers
IC/OC PWM
UART w/IrDA
®
SPI
PIC24FJ128DA106 64 128K 24K 29 5 9/9 4 3 3 16 3 Y N Y Y Y
PIC24FJ256DA106 64 256K 24K 29 5 9/9 4 3 3 16 3 Y N Y Y Y
PIC24FJ128DA110 100/121 128K 24K 44 5 9/9 4 3 3 24 3 Y Y Y Y Y
PIC24FJ256DA110 100/121 256K 24K 44 5 9/9 4 3 3 24 3 Y Y Y Y Y
PIC24FJ128DA206 64 128K 96K 29 5 9/9 4 3 3 16 3 Y N Y Y Y
PIC24FJ256DA206 64 256K 96K 29 5 9/9 4 3 3 16 3 Y N Y Y Y
PIC24FJ128DA210 100/121 128K 96K 44 5 9/9 4 3 3 24 3 Y Y Y Y Y
PIC24FJ256DA210 100/121 256K 96K 44 5 9/9 4 3 3 24 3 Y Y Y Y Y
64/100-Pin, 16-Bit Flash Microcontrollers
with Graphics Controller and USB On-The-Go (OTG)