Datasheet

 2011-2013 Microchip Technology Inc. DS39995D-page 277
PIC24FV32KA304 FAMILY
FIGURE 29-4: EXTERNAL CLOCK TIMING
OSCI
CLKO
Q4 Q1 Q2 Q3 Q4 Q1
OS20
OS25
OS30 OS30
OS40
OS41
OS31
OS31
Q1 Q2 Q3 Q4 Q2 Q3
TABLE 29-19: EXTERNAL CLOCK TIMING REQUIREMENTS
AC CHARACTERISTICS
Standard Operating Conditions: 1.8V to 3.6V PIC24F32KA3XX
2.0V to 5.5V PIC24FV32KA3XX
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Param
No.
Sym Characteristic Min Typ
(1)
Max Units Conditions
OS10 F
OSC External CLKI Frequency
(External clocks allowed
only in EC mode)
DC
4
—
—
32
8
MHz
MHz
EC
ECPLL
OS15 Oscillator Frequency 0.2
4
4
31
—
—
—
—
4
25
8
33
MHz
MHz
MHz
kHz
XT
HS
XTPLL
SOSC
OS20 T
OSC TOSC = 1/FOSC — — — — See Parameter OS10 for FOSC
value
OS25 T
CY Instruction Cycle Time
(2)
62.5 — DC ns
OS30 TosL,
TosH
External Clock in (OSCI)
High or Low Time
0.45 x T
OSC ——nsEC
OS31 TosR,
TosF
External Clock in (OSCI)
Rise or Fall Time
——20nsEC
OS40 TckR CLKO Rise Time
(3)
—610ns
OS41 TckF CLKO Fall Time
(3)
—610ns
Note 1: Data in “Typ” column is at 3.3V, +25°C unless otherwise stated. Parameters are for design guidance only
and are not tested.
2: The instruction cycle period (T
CY) equals two times the input oscillator time base period. All specified values
are based on characterization data for that particular oscillator type, under standard operating conditions,
with the device executing code. Exceeding these specified limits may result in an unstable oscillator
operation and/or higher than expected current consumption. All devices are tested to operate at “Min.”
values with an external clock applied to the OSCI/CLKI pin. When an external clock input is used, the “Max.”
cycle time limit is “DC” (no clock) for all devices.
3: Measurements are taken in EC mode. The CLKO signal is measured on the OSCO pin. CLKO is low for
the Q1-Q2 period (1/2 T
CY) and high for the Q3-Q4 period (1/2 TCY).