Datasheet

PIC24FV32KA304 FAMILY
DS39995D-page 202  2011-2013 Microchip Technology Inc.
REGISTER 20-1: CRCCON1: CRC CONTROL REGISTER 1
R/W-0 U-0 R/W-0 R-0 R-0 R-0 R-0 R-0
CRCEN
— CSIDL VWORD4 VWORD3 VWORD2 VWORD1 VWORD0
bit 15 bit 8
R-0, HSC R-1, HSC R/W-0 R/W-0, HC R/W-0 U-0 U-0 U-0
CRCFUL CRCMPT CRCISEL CRCGO LENDIAN
— — —
bit 7 bit 0
Legend: HC = Hardware Clearable bit HSC = Hardware Settable/Clearable bit
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15 CRCEN: CRC Enable bit
1 = Module is enabled
0 = Module is enabled
All state machines, pointers and CRCWDAT/CRCDAT registers are reset; other SFRs are NOT reset.
bit 14 Unimplemented: Read as ‘0’
bit 13 CSIDL: CRC Stop in Idle Mode bit
1 = Discontinues module operation when device enters Idle mode
0 = Continues module operation in Idle mode
bit 12-8 VWORD<4:0>: Pointer Value bits
Indicates the number of valid words in the FIFO, which has a maximum value of 8 when PLEN<4:0> > 7
or 16 when PLEN<4:0> 7.
bit 7 CRCFUL: CRC FIFO Full bit
1 = FIFO is full
0 = FIFO is not full
bit 6 CRCMPT: CRC FIFO Empty Bit
1 = FIFO is empty
0 = FIFO is not empty
bit 5 CRCISEL: CRC interrupt Selection bit
1 = Interrupt on FIFO is empty; CRC calculation is not complete
0 = Interrupt on shift is complete and CRCWDAT result is ready
bit 4 CRCGO: Start CRC bit
1 = Starts CRC serial shifter
0 = CRC serial shifter is turned off
bit 3 LENDIAN: Data Shift Direction Select bit
1 = Data word is shifted into the CRC, starting with the LSb (little endian)
0 = Data word is shifted into the CRC, starting with the MSb (big endian)
bit 2-0 Unimplemented: Read as ‘0’