Datasheet

PIC24F16KL402 FAMILY
DS30001037C-page 138  2011-2013 Microchip Technology Inc.
REGISTER 17-1: SSPxSTAT: MSSPx STATUS REGISTER (SPI MODE)
U-0 U-0 U-0 U-0 U-0 U-0 U-0 U-0
— — — — — — — —
bit 15 bit 8
R/W-0 R/W-0 R-0 R-0 R-0 R-0 R-0 R-0
SMP CKE
(1)
D/A PSR/WUA BF
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15-8 Unimplemented: Read as ‘0’
bit 7 SMP: Sample bit
SPI Master mode:
1 = Input data is sampled at the end of data output time
0 = Input data is sampled at the middle of data output time
SPI Slave mode:
SMP must be cleared when SPI is used in Slave mode.
bit 6 CKE: SPI Clock Select bit
(1)
1 = Transmit occurs on transition from active to Idle clock state
0 = Transmit occurs on transition from Idle to active clock state
bit 5 D/A: Data/Address bit
Used in I
2
C™ mode only.
bit 4 P: Stop bit
Used in I
2
C mode only. This bit is cleared when the MSSPx module is disabled; SSPEN is cleared.
bit 3 S: Start bit
Used in I
2
C mode only.
bit 2 R/W
: Read/Write Information bit
Used in I
2
C mode only.
bit 1 UA: Update Address bit
Used in I
2
C mode only.
bit 0 BF: Buffer Full Status bit
1 = Receive is complete, SSPxBUF is full
0 = Receive is not complete, SSPxBUF is empty
Note 1: The polarity of the clock state is set by the CKP bit (SSPxCON1<4>).