Information

PIC18F2525/2620/4525/4620

R/W-0 R-1 R/W-0 R/W-0 R/W-0 U-0 R/W-0 R/W-0

ABDOVF RCIDL RXDTP TXCKP BRG16

— WUE ABDEN

bit 7 bit 0

Legend:

R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’

-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown

bit 7 ABDOVF: Auto-Baud Acquisition Rollover Status bit

1 = A BRG rollover has occurred during Auto-Baud Rate Detect mode (must be cleared in software)

0 = No BRG rollover has occurred

bit 6 RCIDL: Receive Operation Idle Status bit

1 = Receive operation is Idle

0 = Receive operation is Active

bit 5 RXDTP: Receive Data Polarity Select bit (Asynchronous mode only)

Asynchronous mode:

1 = Receive data (RX) is inverted. Idle state is a low level.

0 = No inversion of receive data (RX). Idle state is a high level.

bit 4 TXCKP: Transmit/Clock Polarity Select bit

Asynchronous mode:

1 = Transmit data (TX) is inverted. Idle state is a low level.

0 = No inversion of transmit data (TX). Idle state is a high level.

Synchronous mode:

1 = Idle state for clock (CK) is a high level

0 = Idle state for clock (CK) is a low level

bit 3 BRG16: 16-bit Baud Rate Register Enable bit

1 = 16-bit Baud Rate Generator – SPBRGH and SPBRG

0 = 8-bit Baud Rate Generator – SPBRG only (Compatible mode); SPBRGH value ignored

bit 2 Unimplemented: Read as ‘0’

bit 1 WUE: Wake-up Enable bit

Asynchronous mode:

1 = EUSART will continue to sample the RX pin with the interrupt generated on the falling edge; bit

cleared in hardware on following rising edge

0 = RX pin is not monitored or rising edge detected

Synchronous mode:

Unused in this mode.

bit 0 ABDEN: Auto-Baud Detect Enable bit

Asynchronous mode:

1 = Enable baud rate measurement on the next character. Requires reception of a Sync field (55h);

cleared in hardware upon completion.

0 = Baud rate measurement disabled or completed

Synchronous mode:

Unused in this mode.