Datasheet

PIC18F87J72 FAMILY
DS39979A-page 142 Preliminary  2010 Microchip Technology Inc.
REGISTER 15-2: RTCCAL: RTCC CALIBRATION REGISTER
R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0
CAL7 CAL6 CAL5 CAL4 CAL3 CAL2 CAL1 CAL0
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 7-0 CAL<7:0>: RTC Drift Calibration bits
01111111 = Maximum positive adjustment; adds 508 RTC clock pulses every minute
.
.
.
00000001 = Minimum positive adjustment; adds four RTC clock pulses every minute
00000000 = No adjustment
11111111 = Minimum negative adjustment; subtracts four RTC clock pulses every minute
.
.
.
10000000 = Maximum negative adjustment; subtracts 512 RTC clock pulses every minute
REGISTER 15-3: PADCFG1: PAD CONFIGURATION REGISTER
U-0 U-0 U-0 U-0 U-0 R/W-0 R/W-0 U-0
— — — — — RTSECSEL1
(1)
RTSECSEL0
(1)
—
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 7-3 Unimplemented: Read as ‘0’
bit 2-1 RTSECSEL<1:0>: RTCC Seconds Clock Output Select bits
(1)
11 = Reserved; do not use
10 = RTCC source clock is selected for the RTCC pin (pin can be INTOSC or Timer1 oscillator,
depending on the RTCOSC (CONFIG3L<1>) bit setting)
(2)
01 = RTCC seconds clock is selected for the RTCC pin
00 = RTCC alarm pulse is selected for the RTCC pin
bit 0 Unimplemented: Read as ‘0’
Note 1: To enable the actual RTCC output, the RTCOE (RTCCFG<2>) bit must be set.
2: If the Timer1 oscillator is the clock source for RTCC, T1OSCEN bit should be set (T1CON<3> = 1).