Datasheet

© 2009 Microchip Technology Inc. DS39663F-page 359
PIC18F87J10 FAMILY
IPU Weak Pull-up Current
D070 I
PURB PORTB Weak Pull-up Current 30 240 μAVDD = 3.3V, VPIN = VSS
VOL Output Low Voltage
D080 I/O Ports (PORTB, PORTC) — 0.4 V I
OL = 8.5 mA, VDD 3.3V
I/O Ports (PORTD, PORTE,
PORTJ)
—0.4VI
OL = 3.4 mA, VDD 3.3V
I/O Ports (PORTA, PORTF,
PORTG, PORTH)
—0.4VI
OL = 3.4 mA, VDD 3.3V
D083 OSC2/CLKO
(EC, ECIO modes)
—0.4VI
OL = 1.0 mA, VDD 3.3V
V
OH Output High Voltage
(3)
D090 I/O Ports (PORTB, PORTC) 2.4 — V
IOL = -6 mA, VDD 3.3V
I/O Ports (PORTD, PORTE,
PORTJ)
2.4 — V I
OL = -2 mA, VDD 3.3V
I/O Ports (PORTA, PORTF,
PORTG, PORTH)
2.4 — V I
OL = -2 mA, VDD 3.3V
D092 OSC2/CLKO
(EC, ECIO modes)
2.4 — V I
OL = 1 mA, VDD 3.3V
Capacitive Loading Specs
on Output Pins
D100
(4)
COSC2 OSC2 Pin
—
15 pF In HS mode when
external clock is used to drive
OSC1
D101 CIO All I/O Pins — 50 pF To meet the AC Timing
Specifications
D102 C
B SCLx, SDAx — 400 pF I
2
C™ Specification
27.3 DC Characteristics: PIC18F87J10 Family (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Param
No.
Symbol Characteristic Min Max Units Conditions
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC
®
device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Refer to Table 11-2 for the pins that have corresponding tolerance limits.