Datasheet

PIC18F87K22 FAMILY
DS39960D-page 242  2009-2011 Microchip Technology Inc.
FIGURE 18-6: TIMER PULSE GENERATION
18.4 Sleep Mode
The timer and alarm continue to operate while in Sleep
mode. The operation of the alarm is not affected by
Sleep, as an alarm event can always wake up the CPU.
The Idle mode does not affect the operation of the timer
or alarm.
18.5 Reset
18.5.1 DEVICE RESET
When a device Reset occurs, the ALRMRPT register is
forced to its Reset state, causing the alarm to be
disabled (if enabled prior to the Reset). If the RTCC
was enabled, it will continue to operate when a basic
device Reset occurs.
18.5.2 POWER-ON RESET (POR)
The RTCCFG and ALRMRPT registers are reset only
on a POR. Once the device exits the POR state, the
clock registers should be reloaded with the desired
values.
The timer prescaler values can be reset only by writing
to the SECONDS register. No device Reset can affect
the prescalers.
RTCEN bit
ALRMEN bit
RTCC Alarm Event
RTCC Pin