Datasheet

 2003-2013 Microchip Technology Inc. DS30491D-page 347
PIC18F6585/8585/6680/8680
REGISTER 24-1: CONFIG1H: CONFIGURATION REGISTER 1 HIGH (BYTE ADDRESS 300001h)
U-0 U-0 R/P-1 U-0 R/P-1 R/P-1 R/P-1 R/P-1
— — OSCSEN — FOSC3 FOSC2 FOSC1 FOSC0
bit 7 bit 0
bit 7-6 Unimplemented: Read as ‘0’
bit 5 OSCSEN
: Oscillator System Clock Switch Enable bit
1 = Oscillator system clock switch option is disabled (main oscillator is source)
0 = Timer1 oscillator system clock switch option is enabled (oscillator switching is enabled)
bit 4 Unimplemented: Read as ‘0’
bit 3-0 FOSC3:FOSC0: Oscillator Selection bits
1111 = RC oscillator with OSC2 configured as RA6
1110 = HS oscillator with SW enabled 4x PLL
1101 = EC oscillator with OSC2 configured as RA6 and SW enabled 4x PLL
1100 = EC oscillator with OSC2 configured as RA6 and HW enabled 4x PLL
1011 = Reserved; do not use
1010 = Reserved; do not use
1001 = Reserved; do not use
1000 = Reserved; do not use
0111 = RC oscillator with OSC2 configured as RA6
0110 = HS oscillator with HW enabled 4x PLL
0101 = EC oscillator with OSC2 configured as RA6
0100 = EC oscillator with OSC2 configured as divide by 4 clock output
0011 = RC oscillator with OSC2 configured as divide by 4 clock output
0010 = HS oscillator
0001 = XT oscillator
0000 = LP oscillator
Legend:
R = Readable bit P = Programmable bit U = Unimplemented bit, read as ‘0’
- n = Value when device is unprogrammed u = Unchanged from programmed state
18F8680.book Page 347 Tuesday, January 29, 2013 1:32 PM