Datasheet
2009-2011 Microchip Technology Inc. DS39957D-page 119
PIC18F87K90 FAMILY
EXAMPLE 7-3: WRITING TO FLASH PROGRAM MEMORY (CONTINUED)
7.5.2 WRITE VERIFY
Depending on the application, good programming
practice may dictate that the value written to the
memory should be verified against the original value.
This should be used in applications where excessive
writes can stress bits near the specification limit.
7.5.3 UNEXPECTED TERMINATION OF
WRITE OPERATION
If a write is terminated by an unplanned event, such as
loss of power or an unexpected Reset, the memory
location just programmed should be verified and repro-
grammed if needed. If the write operation is interrupted
by a MCLR
Reset or a WDT Time-out Reset during
normal operation, the user can check the WRERR bit
and rewrite the location(s) as needed.
7.5.4 PROTECTION AGAINST
SPURIOUS WRITES
To protect against spurious writes to Flash program
memory, the write initiate sequence must also be
followed. See Section 28.0 “Special Features of the
CPU” for more details.
7.6 Flash Program Operation During
Code Protection
See Section 28.6 “Program Verification and Code
Protection” for details on code protection of Flash
program memory.
TABLE 7-2: REGISTERS ASSOCIATED WITH PROGRAM FLASH MEMORY
PROGRAM_MEMORY
BSF EECON1, EEPGD ; point to Flash program memory
BCF EECON1, CFGS ; access Flash program memory
BSF EECON1, WREN ; enable write to memory
BCF INTCON, GIE ; disable interrupts
MOVLW 0x55
Required MOVWF EECON2 ; write 55h
Sequence MOVLW 0xAA
MOVWF EECON2 ; write 0AAh
BSF EECON1, WR ; start program (CPU stall)
BSF INTCON, GIE ; re-enable interrupts
BCF EECON1, WREN ; disable write to memory
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Reset
Values on
Page:
TBLPTRU — —bit 21
(1)
Program Memory Table Pointer Upper Byte (TBLPTR<20:16>) 75
TBPLTRH Program Memory Table Pointer High Byte (TBLPTR<15:8>) 75
TBLPTRL Program Memory Table Pointer Low Byte (TBLPTR<7:0>) 75
TABLAT Program Memory Table Latch 75
INTCON GIE/GIEH PEIE/GIEL TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF 75
EECON2 EEPROM Control Register 2 (not a physical register) 79
EECON1 EEPGD CFGS
— FREE WRERR WREN WR RD 79
IPR6
— — — EEIP — CMP3IP CMP2IP CMP1IP 77
PIR6
— — — EEIF — CMP3IF CMP2IF CMP1IF 77
PIE6
— — — EEIE — CMP3IE CMP2IE CMP1IE 80
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used during Flash/EEPROM access.
Note 1: Bit 21 of TBLPTRU allows access to the device Configuration bits.