Datasheet

PIC18F85J90 FAMILY
DS39770C-page 362  2010 Microchip Technology Inc.
26.2 DC Characteristics: Power-Down and Supply Current
PIC18F85J90 Family (Industrial)
PIC18F85J90 Family
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for industrial
Param
No.
Device Typ Max Units Conditions
Power-Down Current (I
PD)
(1)
All devices 0.2 0.9 µA -40°C
V
DD = 2.0V,
V
DDCORE = 2.0V
(Sleep mode)
(4)
0.1 0.9 µA +25°C
0.3 3 µA +60°C
2.4 5 µA +85°C
All devices 0.5 0.9 µA -40°C
V
DD = 2.5V,
V
DDCORE = 2.5V
(Sleep mode)
(4)
0.1 0.9 µA +25°C
0.4 3 µA +60°C
2.7 5 µA +85°C
All devices 2.7 6 µA -40°C
V
DD = 3.3V
(Sleep mode)
(5)
3.5 6 µA +25°C
4.1 8 µA +60°C
6.7 12 µA +85°C
Note 1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in a high-impedance state and tied to V
DD or VSS, and all features that add delta
current disabled (such as WDT, Timer1 oscillator, BOR, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all I
DD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to V
DD;
MCLR
= VDD; WDT enabled/disabled as specified.
3: Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
4: Voltage regulator is disabled (ENVREG tied to V
SS).
5: Voltage regulator is enabled (ENVREG tied to V
DD).
6: Resistor ladder current is not included.
7: Connecting an actual display will increase the current consumption depending on the size of the LCD.