Datasheet

PIC18F6585/8585/6680/8680
DS30491D-page 232  2003-2013 Microchip Technology Inc.
REGISTER 18-3: BAUDCON: BAUD RATE CONTROL REGISTER
U-0 R-1 U-0 R/W-0 R/W-0 U-0 R/W-0 R/W-0
— RCIDL —SCKPBRG16— WUE ABDEN
bit 7 bit 0
bit 7 Unimplemented: Read as ‘0’
bit 6 RCIDL: Receive Operation Idle Status bit
1 = Receive operation is Idle
0 = Receive operation is active
bit 5 Unimplemented: Read as ‘0’
bit 4 SCKP: Synchronous Clock Polarity Select bit
Asynchronous mode:
Unused in this mode.
Synchronous mode:
1 = Idle state for clock (CK) is a high level
0 = Idle state for clock (CK) is a low level
bit 3 BRG16: 16-bit Baud Rate Register Enable bit
1 = 16-bit Baud Rate Generator – SPBRGH and SPBRG
0 = 8-bit Baud Rate Generator – SPBRG only (Compatible mode), SPBRGH value ignored
bit 2 Unimplemented: Read as ‘0’
bit 1 WUE: Wake-up Enable bit
Asynchronous mode:
1 = USART will continue to sample the RX pin – interrupt generated on falling edge; bit cleared
in hardware on following rising edge
0 = RX pin not monitored or rising edge detected
Synchronous mode:
Unused in this mode.
bit 0 ABDEN: Auto-Baud Detect Enable bit
Asynchronous mode:
1 = Enable baud rate measurement on the next character – requires reception of a sync field
(55h); cleared in hardware upon completion
0 = Baud rate measurement disabled or completed
Synchronous mode:
Unused in this mode.
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
- n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
18F8680.book Page 232 Tuesday, January 29, 2013 1:32 PM