Datasheet

 2009-2011 Microchip Technology Inc. DS39957D-page 83
PIC18F87K90 FAMILY
SSP2CON2 PIC18F6XK90 PIC18F8XK90 0000 0000 0000 0000 uuuu uuuu
LCDREF PIC18F6XK90 PIC18F8XK90 0000 0000 0000 0000 uuuu uuuu
LCDRL PIC18F6XK90 PIC18F8XK90 0000 -000 0000 -000 uuuu -uuu
LCDSE5
PIC18F6XK90 PIC18F8XK90 0000 0000 0000 0000 uuuu uuuu
LCDSE4 PIC18F6XK90 PIC18F8XK90 ---- ---0 ---- ---u ---- ---u
LCDSE4
PIC18F6XK90 PIC18F8XK90 0000 0000 uuuu uuuu uuuu uuuu
LCDSE3 PIC18F6XK90 PIC18F8XK90 0000 0000 uuuu uuuu uuuu uuuu
LCDSE2 PIC18F6XK90 PIC18F8XK90 0000 0000 uuuu uuuu uuuu uuuu
LCDSE1 PIC18F6XK90 PIC18F8XK90 0000 0000 uuuu uuuu uuuu uuuu
LCDSE0 PIC18F6XK90 PIC18F8XK90 0000 0000 uuuu uuuu uuuu uuuu
LCDPS PIC18F6XK90 PIC18F8XK90 0000 0000 0000 0000 uuuu uuuu
LCDCON PIC18F6XK90 PIC18F8XK90 000- 0000 000- 0000 uuu- uuuu
TABLE 5-2: INITIALIZATION CONDITIONS FOR ALL REGISTERS (CONTINUED)
Register Applicable Devices
Power-on Reset,
Brown-out Reset
MCLR
Resets,
WDT Reset,
RESET Instruction,
Stack Resets,
CM Resets
Wake-up via WDT
or Interrupt
Legend: u = unchanged, x = unknown, - = unimplemented bit, read as ‘0’, q = value depends on condition.
Shaded cells indicate conditions do not apply for the designated device.
Note 1: When the wake-up is due to an interrupt, and the GIEL or GIEH bit is set, the TOSU, TOSH and TOSL are
updated with the current value of the PC. The STKPTR is modified to point to the next location in the
hardware stack.
2: When the wake-up is due to an interrupt and the GIEL or GIEH bit is set, the PC is loaded with the interrupt
vector (0008h or 0018h).
3: One or more bits in the INTCONx or PIRx registers will be affected (to cause wake-up).
4: See Table 5-1 for the Reset value for a specific condition.