Datasheet

PIC18F6585/8585/6680/8680
DS30491D-page 306  2003-2013 Microchip Technology Inc.
23.2.3.2 Message Acceptance Filters
and Masks
This subsection describes the message acceptance
filters and masks for the CAN receive buffers.
REGISTER 23-37: RXFnSIDH: RECEIVE ACCEPTANCE FILTER n STANDARD IDENTIFIER FILTER
REGISTERS, HIGH BYTE [0  n  15]
(1)
REGISTER 23-38: RXFnSIDL: RECEIVE ACCEPTANCE FILTER n STANDARD IDENTIFIER FILTER
REGISTERS, LOW BYTE [0  n  15]
(1)
Note: These registers are writable in
Configuration mode only.
R/W-x R/W-x R/W-x R/W-x R/W-x R/W-x R/W-x R/W-x
SID10 SID9 SID8 SID7 SID6 SID5 SID4 SID3
bit 7 bit 0
bit 7-0 SID10:SID3: Standard Identifier Filter bits, if EXIDEN = 0;
Extended Identifier Filter bits EID28:EID21, if EXIDEN = 1.
Note 1: Registers RXF6SIDH:RXF15SIDH are available in Mode 1 and 2 only.
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
- n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
R/W-x R/W-x R/W-x U-0 R/W-x U-0 R/W-x R/W-x
SID2 SID1 SID0
— EXIDEN —EID17EID16
bit 7 bit 0
bit 7-5 SID2:SID0: Standard Identifier Filter bits, if EXIDEN = 0;
Extended Identifier Filter bits EID20:EID18, if EXIDEN = 1.
bit 4 Unimplemented: Read as ‘0’
bit 3 EXIDEN: Extended Identifier Filter Enable bit
1 = Filter will only accept extended ID messages
0 = Filter will only accept standard ID messages
Note: In Mode 0, this bit must be set/cleared as required, irrespective of corresponding
mask register value.
bit 2 Unimplemented: Read as ‘0’
bit 1-0 EID17:EID16: Extended Identifier Filter bits
Note 1: Registers RXF6SIDL:RXF15SIDL are available in Mode 1 and 2 only.
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
- n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
18F8680.book Page 306 Tuesday, January 29, 2013 1:32 PM