Datasheet

© 2007 Microchip Technology Inc. DS39629C-page 371
PIC18F6390/6490/8390/8490
FIGURE 26-6: CLKO AND I/O TIMING
TABLE 26-9: CLKO AND I/O TIMING REQUIREMENTS
Note: Refer to Figure 26-4 for load conditions.
OSC1
CLKO
I/O pin
(Input)
I/O pin
(Output)
Q4
Q1
Q2 Q3
10
13
14
17
20, 21
19
18
15
11
12
16
Old Value
New Value
Param
No.
Symbol Characteristic Min Typ Max Units Conditions
10 T
OSH2CKLOSC1 ↑ to CLKO ↓ — 75 200 ns (Note 1)
11 TOSH2CKHOSC1 ↑ to CLKO ↑ — 75 200 ns (Note 1)
12 T
CKR CLKO Rise Time — 35 100 ns (Note 1)
13 TCKF CLKO Fall Time — 35 100 ns (Note 1)
14 TCKL2IOVCLKO ↓ to Port Out Valid — — 0.5 TCY + 20 ns (Note 1)
15 T
IOV2CKH Port In Valid before CLKO ↑ 0.25 TCY + 25 — — ns (Note 1)
16 TCKH2IOI Port In Hold after CLKO ↑ 0——ns(Note 1)
17 TOSH2IOVOSC1↑ (Q1 cycle) to Port Out Valid — 50 150 ns
18 T
OSH2IOIOSC1↑ (Q2 cycle) to
Port Input Invalid
(I/O in hold time)
PIC18FXXXX 100 — — ns
18A PIC18LFXXXX 200 — — ns V
DD = 2.0V
19 T
IOV2OSH Port Input Valid to OSC1↑ (I/O in setup time) 0 — — ns
20 TIOR Port Output Rise Time PIC18FXXXX — 10 25 ns
20A PIC18LFXXXX — — 60 ns VDD = 2.0V
21 T
IOF Port Output Fall Time PIC18FXXXX — 10 25 ns
21A PIC18LFXXXX — — 60 ns VDD = 2.0V
22† TINP INTx pin High or Low Time TCY ——ns
23† T
RBP RB7:RB4 Change INTx High or Low Time TCY ——ns
† These parameters are asynchronous events not related to any internal clock edges.
Note 1: Measurements are taken in RC mode, where CLKO output is 4 x TOSC.