Datasheet

PIC18F47J53 FAMILY
DS39964B-page 396 Preliminary  2010 Microchip Technology Inc.
23.5.1.1 Bus Activity Detect Interrupt Bit
(ACTVIF)
The ACTVIF bit cannot be cleared immediately after
the USB module wakes up from Suspend mode or
while the USB module is suspended. A few clock
cycles are required to synchronize the internal hard-
ware state machine before the ACTVIF bit can be
cleared by firmware. Clearing the ACTVIF bit before
the internal hardware is synchronized may not have an
effect on the value of ACTVIF. Additionally, if the USB
module uses the clock from the 96 MHz PLL source,
then after clearing the SUSPND bit, the USB module
may not be immediately operational while waiting for
the 96 MHz PLL to lock. The application code should
clear the ACTVIF flag as provided in Example 23-1.
EXAMPLE 23-1: CLEARING ACTVIF BIT (UIR<2>)
Note: Only one ACTVIF interrupt is generated
when resuming from the USB bus Idle con-
dition. If user firmware clears the ACTVIF
bit, the bit will not immediately become set
again, even when there is continuous bus
traffic. Bus traffic must cease long enough
to generate another IDLEIF condition
before another ACTVIF interrupt can be
generated.
Assembly:
BCF UCON, SUSPND
LOOP:
BTFSS UIR, ACTVIF
BRA DONE
BCF UIR, ACTVIF
BRA LOOP
DONE:
C:
UCONbits.SUSPND = 0;
while (UIRbits.ACTVIF) { UIRbits.ACTVIF = 0; }