Datasheet

© 2007 Microchip Technology Inc. Preliminary DS39625C-page 239
PIC18F2585/2680/4585/4680
FIGURE 18-7: ASYNCHRONOUS RECEPTION
TABLE 18-6: REGISTERS ASSOCIATED WITH ASYNCHRONOUS RECEPTION
Start
bit
bit 7/8
bit 1bit 0 bit 7/8
bit 0
Stop
bit
Start
bit
Start
bit
bit 7/8
Stop
bit
RX (pin)
Rcv Buffer Reg
Rcv Shift Reg
Read Rcv
Buffer Reg
RCREG
RCIF
(Interrupt Flag)
OERR bit
CREN
Word 1
RCREG
Word 2
RCREG
Stop
bit
Note: This timing diagram shows three words appearing on the RX input. The RCREG (receive buffer) is read after the third word
causing the OERR (overrun) bit to be set.
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Reset
Values
on page
INTCON GIE/GIEH PEIE/GIEL
TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF 49
PIR1 PSPIF
(1)
ADIF RCIF TXIF SSPIF CCP1IF TMR2IF TMR1IF 52
PIE1 PSPIE
(1)
ADIE RCIE TXIE SSPIE CCP1IE TMR2IE TMR1IE 52
IPR1
PSPIP
(1)
ADIP RCIP TXIP SSPIP CCP1IP TMR2IP TMR1IP 52
RCSTA SPEN RX9 SREN CREN ADDEN FERR OERR RX9D 51
RCREG EUSART Receive Register 51
TXSTA
CSRC TX9 TXEN SYNC SENDB BRGH TRMT TX9D 51
BAUDCON ABDOVF RCIDL — SCKP BRG16 — WUE ABDEN 51
SPBRGH EUSART Baud Rate Generator Register High Byte 51
SPBRG EUSART Baud Rate Generator Register Low Byte 51
Legend: — = unimplemented locations read as ‘0’. Shaded cells are not used for asynchronous reception.
Note 1: Reserved in PIC18F2X8X devices; always maintain these bits clear.