Datasheet

PIC18F2585/2680/4585/4680
DS39625C-page 426 Preliminary © 2007 Microchip Technology Inc.
27.3 DC Characteristics: PIC18F2585/2680/4585/4680 (Industrial)
PIC18LF2585/2680/4585/4680 (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for industrial
Param
No.
Symbol Characteristic Min Max Units Conditions
V
IL Input Low Voltage
I/O ports:
D030 with TTL buffer V
SS 0.15 VDD VVDD < 4.5V
D030A — 0.8 V 4.5V ≤ V
DD ≤ 5.5V
D031
D031A
D031B
with Schmitt Trigger buffer
RC3 and RC4
VSS
VSS
VSS
0.2 VDD
0.3 VDD
0.8
V
V
V
I
2
C™ enabled
SMBus enabled
D032 MCLR
VSS 0.2 VDD V
D033 OSC1 V
SS 0.3 VDD V HS, HSPLL modes
D033A OSC1 VSS 0.2 VDD V RC, EC modes
(1)
D033B OSC1 VSS 0.3 V XT, LP modes
D034 T13CKI VSS 0.3 V
VIH Input High Voltage
I/O ports:
D040 with TTL buffer 0.25 V
DD + 0.8V VDD VVDD < 4.5V
D040A 2.0 VDD V4.5V ≤ VDD ≤ 5.5V
D041
D041A
D041B
with Schmitt Trigger buffer
RC3 and RC4
0.8 V
DD
0.7 VDD
2.1
V
DD
VDD
VDD
V
V
V
I
2
C™ enabled
SMBus enabled
D042 MCLR
0.8 VDD VDD V
D043 OSC1 0.7 V
DD VDD V HS, HSPLL modes
D043A OSC1 0.8 VDD VDD VEC mode
D043B OSC1 0.9 VDD VDD V RC mode
(1)
D043C OSC1 1.6 VDD V XT, LP modes
D044 T13CKI 1.6 VDD V
IIL Input Leakage Current
(2,3)
D060 I/O ports — ±1 μAV
SS ≤ VPIN ≤ VDD,
Pin at high-impedance
D061 MCLR
— ±5 μAVss ≤ VPIN ≤ VDD
D063 OSC1 — ±5 μAVss ≤ VPIN ≤ VDD
I
PU Weak Pull-up Current
D070 IPURB PORTB weak pull-up current 50 400 μAVDD = 5V, VPIN = VSS
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC
®
device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Parameter is characterized but not tested.