Datasheet

PIC18F2585/2680/4585/4680
DS39625C-page 276 Preliminary © 2007 Microchip Technology Inc.
REGISTER 23-1: CANCON: CAN CONTROL REGISTER
Mode 0
R/W-1 R/W-0 R/W-0 R/S-0 R/W-0 R/W-0 R/W-0 U-0
REQOP2 REQOP1 REQOP0 ABAT WIN2 WIN1 WIN0
—
Mode 1
R/W-1 R/W-0 R/W-0 R/S-0 U-0 U-0 U-0 U-0
REQOP2 REQOP1 REQOP0 ABAT
— — — —
Mode 2
R/W-1 R/W-0 R/W-0 R/S-0 R-0 R-0 R-0 R-0
REQOP2 REQOP1 REQOP0 ABAT FP3 FP2 FP1 FP0
bit 7 bit 0
bit 7-5 REQOP2:REQOP0: Request CAN Operation Mode bits
1xx = Request Configuration mode
011 = Request Listen Only mode
010 = Request Loopback mode
001 = Request Disable mode
000 = Request Normal mode
bit 4 ABAT: Abort All Pending Transmissions bit
1 = Abort all pending transmissions (in all transmit buffers)
0 = Transmissions proceeding as normal
bit 3-1 Mode 0:
WIN2:WIN0: Window Address bits
These bits select which of the CAN buffers to switch into the access bank area. This allows
access to the buffer registers from any data memory bank. After a frame has caused an
interrupt, the ICODE3:ICODE0 bits can be copied to the WIN3:WIN0 bits to select the correct
buffer. See Example 23-2 for a code example.
111 = Receive Buffer 0
110 = Receive Buffer 0
101 = Receive Buffer 1
100 = Transmit Buffer 0
011 = Transmit Buffer 1
010 = Transmit Buffer 2
001 = Receive Buffer 0
000 = Receive Buffer 0
bit 0 Unimplemented: Read as ‘0’
bit 4-0 Mode 1:
Unimplemented: Read as ‘0’
Mode 2:
FP3:FP0: FIFO Read Pointer bits
These bits point to the message buffer to be read.
0111:0000 = Message buffer to be read
1111:1000 = Reserved
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown