Datasheet

© 2006 Microchip Technology Inc. DS39564C-page 279
PIC18FXX2
FIGURE 22-13: EXAMPLE SPI MASTER MODE TIMING (CKE = 1)
TABLE 22-12: EXAMPLE SPI MODE REQUIREMENTS (MASTER MODE, CKE = 1)
Param.
No.
Symbol Characteristic Min Max Units Conditions
71 TscH SCK input high time
(Slave mode)
Continuous 1.25 T
CY + 30 — ns
71A Single Byte 40 — ns (Note 1)
72 TscL SCK input low time
(Slave mode)
Continuous 1.25 T
CY + 30 — ns
72A Single Byte 40 — ns (Note 1)
73 TdiV2scH,
TdiV2scL
Setup time of SDI data input to SCK edge 100 — ns
73A T
B2B Last clock edge of Byte1 to the 1st clock edge of Byte2 1.5 TCY + 40 — ns (Note 2)
74 TscH2diL,
TscL2diL
Hold time of SDI data input to SCK edge 100 — ns
75 TdoR SDO data output rise time PIC18FXXX — 25 ns
PIC18LFXXX — 60 ns V
DD = 2V
76 TdoF SDO data output fall time PIC18FXXX — 25 ns
PIC18LFXXX — 60 ns V
DD = 2V
78 TscR SCK output rise time (Master mode) PIC18FXXX — 25 ns
PIC18LFXXX — 60 ns V
DD = 2V
79 TscF SCK output fall time (Master mode) PIC18FXXX — 25 ns
PIC18LFXXX — 60 ns V
DD = 2V
80 TscH2doV,
TscL2doV
SDO data output valid after SCK
edge
PIC18FXXX — 50 ns
PIC18LFXXX — 150 ns VDD = 2V
81 TdoV2scH,
TdoV2scL
SDO data output setup to SCK edge TCY —ns
Note 1: Requires the use of Parameter # 73A.
2: Only if Parameter # 71A and # 72A are used.
SS
SCK
(CKP = 0)
SCK
(CKP = 1)
SDO
SDI
81
71 72
74
75, 76
78
80
MSb
79
73
MSb In
bit6 - - - - - -1
LSb In
bit6 - - - -1
LSb
Note: Refer to Figure 22-4 for load conditions.