Datasheet

PIC18FXX2
DS39564C-page 22 © 2006 Microchip Technology Inc.
2.6.2 OSCILLATOR TRANSITIONS
The PIC18FXX2 devices contain circuitry to prevent
“glitches” when switching between oscillator sources.
Essentially, the circuitry waits for eight rising edges of
the clock source that the processor is switching to. This
ensures that the new clock source is stable and that its
pulse width will not be less than the shortest pulse
width of the two clock sources.
A timing diagram indicating the transition from the main
oscillator to the Timer1 oscillator is shown in
Figure 2-8. The Timer1 oscillator is assumed to be run-
ning all the time. After the SCS bit is set, the processor
is frozen at the next occurring Q1 cycle. After eight syn-
chronization cycles are counted from the Timer1 oscil-
lator, operation resumes. No additional delays are
required after the synchronization cycles.
FIGURE 2-8: TIMING DIAGRAM FOR TRANSITION FROM OSC1 TO TIMER1 OSCILLATOR
The sequence of events that takes place when switch-
ing from the Timer1 oscillator to the main oscillator will
depend on the mode of the main oscillator. In addition
to eight clock cycles of the main oscillator, additional
delays may take place.
If the main oscillator is configured for an external crys-
tal (HS, XT, LP), then the transition will take place after
an oscillator start-up time (T
OST) has occurred. A timing
diagram, indicating the transition from the Timer1 oscil-
lator to the main oscillator for HS, XT and LP modes, is
shown in Figure 2-9.
FIGURE 2-9: TIMING FOR TRANSITION BETWEEN TIMER1 AND OSC1 (HS, XT, LP)
Q3Q2Q1Q4Q3Q2
OSC1
Internal
SCS
(OSCCON<0>)
Program
PC + 2PC
Note 1: Delay on internal system clock is eight oscillator cycles for synchronization.
Q1
T1OSI
Q4 Q1
PC + 4
Q1
Tscs
Clock
Counter
System
Q2 Q3 Q4 Q1
TDLY
TT1P
TOSC
21 34 5678
Q3
Q3 Q4
Q1 Q2 Q3 Q4 Q1 Q2
OSC1
Internal System
SCS
(OSCCON<0>)
Program Counter
PC PC + 2
Note 1: TOST = 1024 TOSC (drawing not to scale).
T1OSI
Clock
OSC2
TOST
Q1
PC + 6
TT1P
TOSC
TSCS
1 234 5678