Datasheet

PIC18F2331/2431/4331/4431
DS39616D-page 322  2010 Microchip Technology Inc.
TBLWT Table Write
Syntax: [ label ] TBLWT ( *; *+; *-; +*)
Operands: None
Operation: if TBLWT*,
(TABLAT)  Holding Register,
TBLPTR – No Change;
if TBLWT*+,
(TABLAT)  Holding Register,
(TBLPTR) + 1  TBLPTR;
if TBLWT*-,
(TABLAT)  Holding Register,
(TBLPTR) – 1  TBLPTR;
if TBLWT+*,
(TBLPTR) + 1  TBLPTR,
(TABLAT)  Holding Register
Status Affected: None
Encoding: 0000 0000 0000 11nn
nn = 0 *
=1 *+
=2 *-
=3 +*
Description: This instruction uses the 3 LSBs of
TBLPTR to determine which of the
8 holding registers the TABLAT is written
to. The holding registers are used to
program the contents of Program Memory
(P.M.). (Refer to Section 8.0 “Flash Pro-
gram Memory” for additional details on
programming Flash memory.)
The TBLPTR (a 21-bit pointer) points to
each byte in the program memory.
TBLPTR has a 2-Mbyte address range.
The LSb of the TBLPTR selects which
byte of the program memory location to
access.
TBLPTR[0] = 0: Least Significant Byte
of Program Memory
Word
TBLPTR[0] = 1: Most Significant Byte
of Program Memory
Word
The TBLWT instruction can modify the
value of TBLPTR as follows:
• no change
• post-increment
• post-decrement
• pre-increment
TBLWT Table Write (Continued)
Words: 1
Cycles: 2
Q Cycle Activity:
Q1 Q2
Q3 Q4
Decode No
operation
No
operation
No
operation
No
operation
No
operation
(Read
TABLAT)
No
operation
No
operation
(Write to
Holding
Register )
Example 1:
TBLWT *+;
Before Instruction
TABLAT = 0x55
TBLPTR = 0x00A356
HOLDING REGISTER
(0x00A356) = 0xFF
After Instructions (table write completion)
TABLAT = 0x55
TBLPTR = 0x00A357
HOLDING REGISTER
(0x00A356) = 0x55
Example 2:
TBLWT +*;
Before Instruction
TABLAT = 0x34
TBLPTR = 0x01389A
HOLDING REGISTER
(0x01389A) = 0xFF
HOLDING REGISTER
(0x01389B) = 0xFF
After Instruction (table write completion)
TABLAT = 0x34
TBLPTR = 0x01389B
HOLDING REGISTER
(0x01389A) = 0xFF
HOLDING REGISTER
(0x01389B) = 0x34