Datasheet

PIC18F47J13 FAMILY
DS39974A-page 366 Preliminary  2010 Microchip Technology Inc.
21.4.2 EUSART SYNCHRONOUS SLAVE
RECEPTION
The operation of the Synchronous Master and Slave
modes is identical, except in the case of Sleep, or any
Idle mode and bit, SREN, which is a “don’t care” in
Slave mode.
If receive is enabled by setting the CREN bit prior to
entering Sleep or any Idle mode, then a word may be
received while in this low-power mode. Once the word
is received, the RSR register will transfer the data to the
RCREGx register. If the RCxIE enable bit is set, the
interrupt generated will wake the chip from the
low-power mode. If the global interrupt is enabled, the
program will branch to the interrupt vector.
To set up a Synchronous Slave Reception:
1. Enable the synchronous master serial port by
setting bits, SYNC and SPEN, and clearing bit,
CSRC.
2. If interrupts are desired, set enable bit, RCxIE.
3. If 9-bit reception is desired, set bit, RX9.
4. To enable reception, set enable bit, CREN.
5. Flag bit, RCxIF, will be set when reception is
complete. An interrupt will be generated if
enable bit, RCxIE, was set.
6. Read the RCSTAx register to get the ninth bit (if
enabled) and determine if any error occurred
during reception.
7. Read the 8-bit received data by reading the
RCREGx register.
8. If any error occurred, clear the error by clearing
bit, CREN.
9. If using interrupts, ensure that the GIE and PEIE
bits in the INTCON register (INTCON<7:6>) are
set.
TABLE 21-10: REGISTERS ASSOCIATED WITH SYNCHRONOUS SLAVE RECEPTION
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
INTCON GIE/GIEH PEIE/GIEL
TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF
PIR1
PMPIF
(1)
ADIF RC1IF TX1IF SSP1IF CCP1IF TMR2IF TMR1IF
PIE1 PMPIE
(1)
ADIE RC1IE TX1IE SSP1IE CCP1IE TMR2IE TMR1IE
IPR1 PMPIP
(1)
ADIP RC1IP TX1IP SSP1IP CCP1IP TMR2IP TMR1IP
PIR3
SSP2IF BCL2IF RC2IF TX2IF TMR4IF CTMUIF TMR3GIF RTCCIF
PIE3 SSP2IE BCL2IE RC2IE TX2IE TMR4IE CTMUIE TMR3GIE RTCCIE
IPR3 SSP2IP BCL2IP RC2IP TX2IP TMR4IP CTMUIP TMR3GIP RTCCIP
RCSTAx SPEN RX9 SREN CREN
ADDEN FERR OERR RX9D
RCREGx EUSARTx Receive Register
TXSTAx CSRC TX9 TXEN SYNC SENDB BRGH TRMT TX9D
BAUDCONx
ABDOVF RCIDL RXDTP TXCKP BRG16 — WUE ABDEN
SPBRGHx EUSARTx Baud Rate Generator High Byte
SPBRGx EUSARTx Baud Rate Generator Low Byte
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used for synchronous slave reception.
Note 1: These pins are only available on 44-pin devices.