Datasheet

PIC18F47J13 FAMILY
DS39974A-page 220 Preliminary  2010 Microchip Technology Inc.
14.2 Timer2 Interrupt
Timer2 can also generate an optional device interrupt.
The Timer2 output signal (TMR2 to PR2 match) pro-
vides the input for the 4-bit output counter/postscaler.
This counter generates the TMR2 Match Interrupt Flag,
which is latched in TMR2IF (PIR1<1>). The interrupt is
enabled by setting the TMR2 Match Interrupt Enable
bit, TMR2IE (PIE1<1>).
A range of 16 postscaler options (from 1:1 through 1:16
inclusive) can be selected with the postscaler control
bits, T2OUTPS<3:0> (T2CON<6:3>).
14.3 Timer2 Output
The unscaled output of TMR2 is available primarily to
the ECCP modules, where it is used as a time base for
operations in PWM mode.
Timer2 can be optionally used as the shift clock source
for the MSSP modules operating in SPI mode.
Additional information is provided in Section 20.0
“Master Synchronous Serial Port (MSSP) Module”.
FIGURE 14-1: TIMER2 BLOCK DIAGRAM
TABLE 14-1: REGISTERS ASSOCIATED WITH TIMER2 AS A TIMER/COUNTER
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
INTCON GIE/GIEH PEIE/GIEL
TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF
PIR1
PMPIF
(1)
ADIF RC1IF TX1IF SSP1IF CCP1IF TMR2IF TMR1IF
PIE1 PMPIE
(1)
ADIE RC1IE TX1IE SSP1IE CCP1IE TMR2IE TMR1IE
IPR1 PMPIP
(1)
ADIP RC1IP TX1IP SSP1IP CCP1IP TMR2IP TMR1IP
TMR2 Timer2 Register
T2CON
— T2OUTPS3 T2OUTPS2 T2OUTPS1 T2OUTPS0 TMR2ON T2CKPS1 T2CKPS0
PR2 Timer2 Period Register
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used by the Timer2 module.
Note 1: These bits are only available in 44-pin devices.
Comparator
TMR2 Output
TMR2
Postscaler
Prescaler
PR2
2
F
OSC/4
1:1 to 1:16
1:1, 1:4, 1:16
4
T2OUTPS<3:0>
T2CKPS<1:0>
Set TMR2IF
Internal Data Bus
8
Reset
TMR2/PR2
8
8
(to PWM or MSSPx)
Match