Datasheet
2010-2012 Microchip Technology Inc. DS39977F-page 553
PIC18F66K80 FAMILY
Supply Current (IDD) Cont.
(2,3)
PIC18LFXXK80 1.4 4 µA -40°C
V
DD = 1.8V
(4)
Regulator Disabled
F
OSC = 32 kHz
(3)
(SEC_IDLE mode,
SOSCSELX = 01)
2.4 6 µA +25°C
3.6 10 µA +60°C
4.6 12 µA +85°C
9.0 20 µA +125°
PIC18
LFXXK80 2 5 µA -40°C
V
DD = 3.3V
(4)
Regulator Disabled
10 18 µA +25°C
11 22 µA +60°C
13 30 µA +85°C
17 40 µA +125°
PIC18FXXK80 55 150 µA +25°C
VDD = 3.3V
(5)
Regulator Enabled
55 150 µA +60°C
55 150 µA +85°C
60 160 µA +125°C
75 170 µA +25°C
PIC18FXXK80 53 160 µA -40°C
VDD = 5V
(5)
Regulator Enabled
62 160 µA +25°C
70 160 µA +60°C
85 170 µA +85°C
100 180 µA +125°C
31.2 DC Characteristics: Power-Down and Supply Current
PIC18F66K80 Family (Industrial/Extended) (Continued)
PIC18F66K80 Family
(Industrial/Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C
TA +125°C for extended
Param
No.
Device Typ Max Units Conditions
Legend:
Shading of rows is to assist in readability of the table.
Note 1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with the
part in Sleep mode, with all I/O pins in a high-impedance state and tied to V
DD or VSS, and all features that add delta
current are disabled (such as WDT, SOSC oscillator, BOR, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on the
current consumption.
The test conditions for all I
DD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to V
DD;
MCLR
= VDD; WDT enabled/disabled as specified.
3: Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
4: For LF devices, RETEN (CONFIG1L<0>) = 1.
5: For F devices, SRETEN (WDTCON<4>) = 1 and RETEN (CONFIG1L<0>) = 0.