Datasheet
2010-2012 Microchip Technology Inc. DS39977F-page 543
PIC18F66K80 FAMILY
Supply Current (IDD) Cont.
(2,3)
PIC18LFXXK80 520 820 µA -40°C
V
DD = 1.8V
(4)
Regulator Disabled
F
OSC = 4 MHz
(
RC_RUN mode,
HF-INTOSC)
520 820 µA +25°C
520 820 µA +60°C
530 880 µA +85°C
540 1000 µA +125°C
PIC18
LFXXK80 941 1600 µA -40°C
VDD = 3.3V
(4)
Regulator Disabled
941 1600 µA +25°C
941 1600 µA +60°C
950 1610 µA +85°C
960 1800 µA +125°C
PIC18FXXK80 981 1640 A -40°C
VDD = 3.3V
(5)
Regulator Enabled
981 1640 A +25°C
981 1640 A +60°C
990 1650 A +85°C
1000 1900 A +125°C
PIC18FXXK80 1 2.2 mA -40°C
VDD = 5V
(5)
Regulator Enabled
1 2.2 mA +25°C
1 2.2 mA +60°C
1 2.2 mA +85°C
1 2.2 mA +125°C
31.2 DC Characteristics: Power-Down and Supply Current
PIC18F66K80 Family (Industrial/Extended) (Continued)
PIC18F66K80 Family
(Industrial/Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C
TA +125°C for extended
Param
No.
Device Typ Max Units Conditions
Legend:
Shading of rows is to assist in readability of the table.
Note 1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with the
part in Sleep mode, with all I/O pins in a high-impedance state and tied to V
DD or VSS, and all features that add delta
current are disabled (such as WDT, SOSC oscillator, BOR, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on the
current consumption.
The test conditions for all I
DD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to V
DD;
MCLR
= VDD; WDT enabled/disabled as specified.
3: Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
4: For LF devices, RETEN (CONFIG1L<0>) = 1.
5: For F devices, SRETEN (WDTCON<4>) = 1 and RETEN (CONFIG1L<0>) = 0.