Datasheet
2010-2012 Microchip Technology Inc. DS39977F-page 541
PIC18F66K80 FAMILY
Supply Current (IDD)
(2,3)
PIC18LFXXK80 4 8 A -40°C
V
DD = 1.8V
(4)
Regulator Disabled
F
OSC = 31 kHz
(
RC_RUN mode,
LF-INTOSC)
48
A +25°C
48
A +60°C
59
A +85°C
912
A +125°C
PIC18
LFXXK80 7 11 A -40°C
VDD = 3.3V
(4)
Regulator Disabled
711
A +25°C
711
A +60°C
812
A +85°C
13 15
A +125°C
PIC18FXXK80 51 150 A -40°C
VDD = 3.3V
(5)
Regulator Enabled
70 150 A +25°C
75 150 A +60°C
80 170 A +85°C
88 190 A +125°C
PIC18FXXK80 75 180 A -40°C
VDD = 5V
(5)
Regulator Enabled
75 180 A +25°C
75 180 A +60°C
80 190 A +85°C
95 200 A +125°C
31.2 DC Characteristics: Power-Down and Supply Current
PIC18F66K80 Family (Industrial/Extended) (Continued)
PIC18F66K80 Family
(Industrial/Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C
TA +125°C for extended
Param
No.
Device Typ Max Units Conditions
Legend:
Shading of rows is to assist in readability of the table.
Note 1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with the
part in Sleep mode, with all I/O pins in a high-impedance state and tied to V
DD or VSS, and all features that add delta
current are disabled (such as WDT, SOSC oscillator, BOR, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on the
current consumption.
The test conditions for all I
DD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to V
DD;
MCLR
= VDD; WDT enabled/disabled as specified.
3: Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
4: For LF devices, RETEN (CONFIG1L<0>) = 1.
5: For F devices, SRETEN (WDTCON<4>) = 1 and RETEN (CONFIG1L<0>) = 0.