Datasheet
PIC18F66K80 FAMILY
DS39977F-page 540 2010-2012 Microchip Technology Inc.
31.2 DC Characteristics: Power-Down and Supply Current
PIC18F66K80 Family (Industrial/Extended)
PIC18F66K80 Family
(Industrial/Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C
TA +125°C for extended
Param
No.
Device Typ Max Units Conditions
Power-Down Current (I
PD)
(1)
PIC18LFXXK80 8 400 nA -40°C
V
DD = 1.8V
(
Sleep mode)
Regulator Disabled
13 500 nA +25°C
35 750 nA +60°C
218 980 nA +85°C
36
A +125°C
PIC18
LFXXK80 14 500 nA -40°C
V
DD = 3.3V
(
Sleep mode)
Regulator Disabled
34 600 nA +25°C
92 850 nA +60°C
312 1250 nA +85°C
4 8 µA +125°C
PIC18FXXK80 200 700 nA -40°C
VDD = 3.3V
(
Sleep mode)
Regulator Enabled
230 800 nA +25°C
320 1050 nA +60°C
510 1500 nA +85°C
5 9 µA +125°C
PIC18FXXK80 220 1000 nA -40°C
VDD = 5V
(
Sleep mode)
Regulator Enabled
240 1000 nA +25°C
340 1100 nA +60°C
540 1580 nA +85°C
5 10 µA +125°C
Legend: Shading of rows is to assist in readability of the table.
Note 1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with the
part in Sleep mode, with all I/O pins in a high-impedance state and tied to V
DD or VSS, and all features that add delta
current are disabled (such as WDT, SOSC oscillator, BOR, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on the
current consumption.
The test conditions for all I
DD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR
= VDD; WDT enabled/disabled as specified.
3: Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
4: For LF devices, RETEN (CONFIG1L<0>) = 1.
5: For F devices, SRETEN (WDTCON<4>) = 1 and RETEN (CONFIG1L<0>) = 0.