Datasheet

 2010-2012 Microchip Technology Inc. DS39977F-page 207
PIC18F66K80 FAMILY
13.3 Prescaler
An 8-bit counter is available as a prescaler for the Timer0
module. The prescaler is not directly readable or writable.
Its value is set by the PSA and T0PS<2:0> bits
(T0CON<3:0>), which determine the prescaler
assignment and prescale ratio.
Clearing the PSA bit assigns the prescaler to the
Timer0 module. When it is assigned, prescale values
from 1:2 through 1:256, in power-of-two increments,
are selectable.
When assigned to the Timer0 module, all instructions
writing to the TMR0 register (for example,
CLRF TMR0,
MOVWF TMR0, BSF TMR0) clear the prescaler count.
13.3.1 SWITCHING PRESCALER
ASSIGNMENT
The prescaler assignment is fully under software
control and can be changed “on-the-fly” during program
execution.
13.4 Timer0 Interrupt
The TMR0 interrupt is generated when the TMR0
register overflows from FFh to 00h in 8-bit mode, or
from FFFFh to 0000h in 16-bit mode. This overflow sets
the TMR0IF flag bit. The interrupt can be masked by
clearing the TMR0IE bit (INTCON<5>). Before re-
enabling the interrupt, the TMR0IF bit must be cleared
in software by the Interrupt Service Routine (ISR).
Since Timer0 is shutdown in Sleep mode, the TMR0
interrupt cannot awaken the processor from Sleep.
TABLE 13-1: REGISTERS ASSOCIATED WITH TIMER0
Note: Writing to TMR0 when the prescaler is
assigned to Timer0 will clear the prescaler
count but will not change the prescaler
assignment.
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
TMR0L Timer0 Register Low Byte
TMR0H Timer0 Register High Byte
INTCON GIE/GIEH PEIE/GIEL TMR0IE
INT0IE RBIE TMR0IF INT0IF RBIF
T0CON TMR0ON T08BIT T0CS T0SE PSA T0PS2 T0PS1 T0PS0
PMD1
PSPMD CTMUMD ADCMD TMR4MD TMR3MD TMR2MD TMR1MD TMR0MD
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used by Timer0.