Datasheet
PIC18F45J10 FAMILY
DS39682E-page 350 © 2009 Microchip Technology Inc.
APPENDIX B: MIGRATION
BETWEEN HIGH-END
DEVICE FAMILIES
Devices in the PIC18F45J10 family and PIC18F4520
families are very similar in their functions and feature
sets. However, there are some potentially important
differences which should be considered when
migrating an application across device families to
achieve a new design goal. These are summarized in
Table B-1. The areas of difference which could be a
major impact on migration are discussed in greater
detail later in this section.
TABLE B-1: NOTABLE DIFFERENCES BETWEEN PIC18F45J10 AND PIC18F4520 FAMILIES
Characteristic PIC18F45J10 Family PIC18F4520 Family
Operating Frequency 40 MHz @ 2.15V 40 MHz @ 4.2V
Supply Voltage 2.0V-3.6V 2.0V-5.5V
Operating Current Low Lower
Program Memory Endurance 1,000 write/erase cycles (typical) 100,000 write/erase cycles (typical)
I/O Sink/Source at 25 mA PORTB and PORTC only All ports
Input Voltage Tolerance on I/O pins 5.5V on digital only pins V
DD on all I/O pins
I/O 32 36
Pull-ups PORTB PORTB
Oscillator Options Limited options
(EC, HS, fixed 32 kHz INTRC)
More options (EC, HS, XT, LP, RC,
PLL, flexible INTRC)
Program Memory Retention 10 years (minimum) 40 years (minimum)
Programming Time (Normalized) 156 μs/byte (10 ms/64-byte block) 15.6 μs/byte (1 ms/64-byte block)
Programming Entry Low Voltage, Key Sequence V
PP and LVP
Code Protection Single block, all or nothing Multiple code protection blocks
Configuration Words Stored in last 4 words of
Program Memory space
Stored in Configuration Space,
starting at 300000h
Start-up Time from Sleep 200 μs (typical) 10 μs (typical)
Power-up Timer Always on Configurable
Data EEPROM Not available Available
Brown-out Reset Simple BOR
(1)
Programmable BOR
LVD Not available Available
A/D Calibration Required Not required
In-Circuit Emulation Not available Available
TMR3 Not available Available
Second MSSP Available
(2)
Not available
Note 1: Brown-out Reset is not available on PIC18LFXXJ10 devices.
2: Available on 40/44-pin devices only.