Datasheet

PIC18F2XK20/4XK20
DS41303G-page 392  2010 Microchip Technology Inc.
FIGURE 26-12: EXAMPLE SPI MASTER MODE TIMING (CKE = 0)
TABLE 26-14: EXAMPLE SPI MODE REQUIREMENTS (MASTER MODE, CKE = 0)
SS
SCK
(CKP = 0)
SCK
(CKP = 1)
SDO
SDI
70
71 72
73
74
75, 76
78
79
80
79
78
MSb LSb
bit 6 - - - - - -1
MSb In
LSb In
bit 6 - - - -1
Note: Refer to Figure 26-4 for load conditions.
Param
No.
Symbol Characteristic Min Max Units Conditions
70 TssL2scH,
TssL2scL
SS
 to SCK  or SCK  Input TCY —ns
71 TscH SCK Input High Time
(Slave mode)
Continuous 1.25 T
CY + 30 — ns
71A Single Byte 40 — ns (Note 1)
72 TscL SCK Input Low Time
(Slave mode)
Continuous 1.25 T
CY + 30 — ns
72A Single Byte 40 — ns (Note 1)
73 TdiV2scH,
TdiV2scL
Setup Time of SDI Data Input to SCK Edge 100 — ns
73A Tb2b Last Clock Edge of Byte 1 to the 1st Clock Edge
of Byte 2
1.5 T
CY + 40 — ns (Note 2)
74 TscH2diL,
TscL2diL
Hold Time of SDI Data Input to SCK Edge 100 — ns
75 TdoR SDO Data Output Rise Time — 25 ns
76 TdoF SDO Data Output Fall Time — 25 ns
78 TscR SCK Output Rise Time
(Master mode)
—25ns
79 TscF SCK Output Fall Time (Master mode) — 25 ns
80 TscH2doV,
TscL2doV
SDO Data Output Valid after SCK Edge — 50 ns
Note 1: Requires the use of Parameter #73A.
2: Only if Parameter #71A and #72A are used.