Datasheet

PIC18F2331/2431/4331/4431
DS39616D-page 358  2010 Microchip Technology Inc.
TABLE 26-16: I
2
C™ BUS DATA REQUIREMENTS (SLAVE MODE)
Param.
No.
Symbol Characteristic Min Max Units Conditions
100 THIGH
Clock High Time 100 kHz mode 4.0 — s PIC18FXX31 must operate at
a minimum of 1.5 MHz
400 kHz mode 0.6 — s PIC18FXX31 must operate at
a minimum of 10 MHz
SSP module 1.5 T
CY —
101 TLOW
Clock Low Time 100 kHz mode 4.7 — s PIC18FXX31 must operate at
a minimum of 1.5 MHz
400 kHz mode 1.3 — s PIC18FXX31 must operate at
a minimum of 10 MHz
SSP Module 1.5 T
CY —
102 TR
SDA and SCL Rise
Time
100 kHz mode — 1000 ns
400 kHz mode 20 + 0.1 C
B 300 ns CB is specified to be from
10 to 400 pF
103 TF
SDA and SCL Fall
Time
100 kHz mode — 300 ns
400 kHz mode 20 + 0.1 C
B 300 ns CB is specified to be from
10 to 400 pF
90 TSU:STA
Start Condition Setup
Time
100 kHz mode 4.7 — s Only relevant for Repeated
Start condition
400 kHz mode 0.6 — s
91 THD:STA
Start Condition Hold
Time
100 kHz mode 4.0 — s After this period, the first clock
pulse is generated
400 kHz mode 0.6 — s
106 THD:DAT
Data Input Hold Time 100 kHz mode 0 — ns
400 kHz mode 0 0.9 s
107 TSU:DAT
Data Input Setup
Time
100 kHz mode 250 — ns (Note 2)
400 kHz mode 100 — ns
92 TSU:STO
Stop Condition Setup
Time
100 kHz mode 4.7 — s
400 kHz mode 0.6 — s
109 TAA
Output Valid From
Clock
100 kHz mode — 3500 ns (Note 1)
400 kHz mode — — ns
110 TBUF
Bus Free Time 100 kHz mode 4.7 — s Time the bus must be free
before a new transmission can
start
400 kHz mode 1.3 — s
D102 C
B Bus Capacitive Loading — 400 pF
Note 1: As a transmitter, the device must provide this internal minimum delay time to bridge the undefined region (min. 300 ns)
of the falling edge of SCL to avoid unintended generation of Start or Stop conditions.
2: A Fast mode I
2
C bus device can be used in a Standard mode I
2
C bus system, but the requirement, TSU:DAT  250 ns,
must then be met. This will automatically be the case if the device does not stretch the LOW period of the SCL signal. If
such a device does stretch the LOW period of the SCL signal, it must output the next data bit to the SDA line,.
T
R max. + TSU:DAT = 1000 + 250 = 1250 ns (according to the Standard mode I
2
C bus specification), before the SCL line
is released.