Datasheet

PIC18F2220/2320/4220/4320
DS39599G-page 328 © 2007 Microchip Technology Inc.
26.4.3 TIMING DIAGRAMS AND SPECIFICATIONS
FIGURE 26-6: EXTERNAL CLOCK TIMING (ALL MODES EXCEPT PLL)
TABLE 26-6: EXTERNAL CLOCK TIMING REQUIREMENTS
OSC1
CLKO
Q4 Q1 Q2 Q3 Q4 Q1
1
2
3
3
4
4
Param.
No.
Symbol Characteristic Min Max Units Conditions
1A F
OSC External CLKI Frequency
(1)
DC 40 MHz EC, ECIO (industrial)
DC 25 MHz EC, ECIO (extended)
Oscillator Frequency
(1)
DC 4 MHz RC osc
0.1 1 MHz XT osc
4 25 MHz HS osc
4 10 MHz HS + PLL osc (industrial)
4 6.25 MHz HS + PLL osc (extended)
5 33 kHz LP Osc mode
1T
OSC External CLKI Period
(1)
25 — ns EC, ECIO (industrial)
40 — ns EC, ECIO (extended)
Oscillator Period
(1)
250 — ns RC osc
1—μsXT osc
40
100
250
250
ns
ns
HS osc
HS + PLL osc (industrial)
160 250 ns HS + PLL osc (extended)
30 — μsLP osc
2TCY Instruction Cycle Time
(1)
100
160
—
—
ns
ns
TCY = 4/FOSC (industrial)
T
CY = 4/FOSC (extended)
3TOSL,
T
OSH
External Clock in (OSC1)
High or Low Time
30 — ns XT osc
2.5 — μsLP osc
10 — ns HS osc
4TOSR,
T
OSF
External Clock in (OSC1)
Rise or Fall Time
— 20 ns XT osc
— 50 ns LP osc
— 7.5 ns HS osc
Note 1: Instruction cycle period (T
CY) equals four times the input oscillator time base period for all configurations
except PLL. All specified values are based on characterization data for that particular oscillator type under
standard operating conditions with the device executing code. Exceeding these specified limits may result
in an unstable oscillator operation and/or higher than expected current consumption. All devices are tested
to operate at “min.” values with an external clock applied to the OSC1/CLKI pin. When an external clock
input is used, the “max.” cycle time limit is “DC” (no clock) for all devices.