Datasheet
PIC18(L)F1XK22
DS41365E-page 340 2009-2011 Microchip Technology Inc.
Power-down Module Current
D032 — .7 1.0 9.0 A 1.8 A/D Current
(1, 4)
, no conversion in
progress
—.83.0 10A3.0
D032 — 19 42 60 A 2.3 A/D Current
(1, 4)
, no conversion in
progress
— 20 44 65 A 3.0
— 22 46 80 A 5.0
D033 — 8 30 32 A 1.8 Comparator Current, low power
C1 and C2 enabled
—11 32 35 A3.0
D033 — 23 55 65 A 2.3 Comparator Current, low power
C1 and C2 enabled
— 31 65 75 A 3.0
— 33 75 95 A 5.0
D033A — 44 110 160 A 1.8 Comparator Current, high power
C1 and C2 enabled
— 65 130 165 A3.0
D033A — 77 137 155 A 2.3 Comparator Current, high power
C1 and C2 enabled
— 84 140 165 A 3.0
— 90 150 180 A 5.0
D034 — 13 18 33 A 1.8 Voltage Reference Current
—22 30 40 A3.0
D034 — 33 55 85 A 2.3 Voltage Reference Current
— 35 80 95 A 3.0
— 48 90 120 A 5.0
25.8 DC Characteristics: Power-Down Current, PIC18(L)F1XK22-I/E
(Industrial, Extended) (Continued)
PIC18LF1XK22
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C T
A +125°C for extended
PIC18F1XK22
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Param
No.
Device Characteristics Min. Typ†
Max.
+85°C
Max.
+125°C
Units
Conditions
V
DD Note
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this peripheral is
enabled. The peripheral current can be determined by subtracting the base I
DD or IPD current from this limit. Max
values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.
3: Fixed Voltage Reference is automatically enabled whenever the BOR is enabled.
4: A/D oscillator source is F
RC.