Datasheet
2009-2011 Microchip Technology Inc. DS41365E-page 339
PIC18(L)F1XK22
25.8 DC Characteristics: Power-Down Current, PIC18(L)F1XK22-I/E
(Industrial, Extended)
PIC18LF1XK22
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C T
A +125°C for extended
PIC18F1XK22
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Param
No.
Device Characteristics Min. Typ†
Max.
+85°C
Max.
+125°C
Units
Conditions
V
DD Note
Power-down Base Current (I
PD)
(2)
D027 — 0.034 1.0 9.0 A 1.8 WDT, BOR, FVR, T1OSC
disabled, all Peripherals Inactive
— 0.071 2.0 10 A3.0
D027 — 17 40 55 A 2.3 WDT, BOR, FVR and T1OSC
disabled, all Peripherals Inactive
— 18 43 65 A 3.0
— 20 45 80 A 5.0
Power-down Module Current
D028 — .46 1.3 10 A 1.8 LPWDT Current
(1)
— .74 3.0 11 A3.0
D028 — 18 44 60 A 2.3 LPWDT Current
(1)
— 21 46 70 A 3.0
— 22 48 85 A 5.0
D029 — 12 20 28 A 1.8 FVR Current
(3)
—14 22 30 A3.0
D029 — 40 65 80 A 2.3 FVR Current
(3)
— 50 70 85 A 3.0
— 70 120 135 A 5.0
D030 — 12 17 23 A 3.0 BOR Current
(1, 3)
D030 — 30 55 80 A 3.0 BOR Current
(1, 3)
— 64 100 120 A 5.0
D031 — .65 1.5 11 A 1.8 T1OSC Current
(1)
— 0.90 4.0 12 A3.0
D031 — 19 45 60 A 2.3 T1OSC Current
(1)
— 20 50 70 A 3.0
— 22 55 80 A 5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this peripheral is
enabled. The peripheral current can be determined by subtracting the base I
DD or IPD current from this limit. Max
values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.
3: Fixed Voltage Reference is automatically enabled whenever the BOR is enabled.
4: A/D oscillator source is F
RC.