Datasheet

© 2007 Microchip Technology Inc. DS39605F-page 265
PIC18F1220/1320
FIGURE 22-14: A/D CONVERSION TIMING
TABLE 22-14: A/D CONVERSION REQUIREMENTS
131
130
132
BSF ADCON0, GO
Q4
A/D CLK
(1)
A/D DATA
ADRES
ADIF
GO
SAMPLE
OLD_DATA
Sampling Stopped
DONE
NEW_DATA
(Note 2)
987 21 0
Note 1: If the A/D clock source is selected as RC, a time of T
CY is added before the A/D clock starts.
This allows the SLEEP instruction to be executed.
2: This is a minimal RC delay (typically 100 ns), which also disconnects the holding capacitor from the analog input.
. . .
. . .
TCY
Param
No.
Symbol Characteristic Min Max Units Conditions
130 T
AD A/D Clock Period PIC18F1X20 1.6 20
(5)
μsTOSC based, VREF ≥ 3.0V
PIC18LF1X20 3.0 20
(5)
μsTOSC based, VREF full range
PIC18F1X20 2.0 6.0 μs A/D RC mode
PIC18LF1X20 3.0 9.0 μs A/D RC mode
131 T
CNV Conversion Time
(not including acquisition time) (Note 1)
11 12 TAD
132 TACQ Acquisition Time (Note 3) 15
10
—
—
μs
μs
-40°C ≤ Temp ≤ +125°C
0°C ≤ Temp ≤ +125°C
135 T
SWC Switching Time from Convert → Sample — (Note 4)
136 T
AMP Amplifier Settling Time (Note 2) 1—μs This may be used if the
“new” input voltage has not
changed by more than 1 LSb
(i.e., 5 mV @ 5.12V) from the
last sampled voltage (as
stated on C
HOLD).
Note 1: ADRES register may be read on the following TCY cycle.
2: See Section 17.0 “10-Bit Analog-to-Digital Converter (A/D) Module” for minimum conditions when input
voltage has changed more than 1 LSb.
3: The time for the holding capacitor to acquire the “New” input voltage, when the voltage changes full scale after
the conversion (AV
DD to AVSS, or AVSS to AVDD). The source impedance (RS) on the input channels is 50Ω.
4: On the next Q4 cycle of the device clock.
5: The time of the A/D clock period is dependent on the device frequency and the TAD clock divider.