Datasheet

© 2007 Microchip Technology Inc. DS39605F-page 241
PIC18F1220/1320
22.2 DC Characteristics: Power-Down and Supply Current
PIC18F1220/1320 (Industrial)
PIC18LF1220/1320 (Industrial)
PIC18LF1220/1320
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for industrial
PIC18F1220/1320
(Industrial, Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for industrial
-40°C ≤ T
A ≤ +125°C for extended
Param
No.
Device Typ Max Units Conditions
Power-Down Current (I
PD)
(1)
PIC18LF1220/1320 0.1 0.5 μA -40°C
V
DD = 2.0V,
(Sleep mode)
0.1 0.5 μA +25°C
0.2 1.9 μA +85°C
PIC18LF1220/1320 0.1 0.5 μA -40°C
V
DD = 3.0V,
(Sleep mode)
0.1 0.5 μA + 25°C
0.3 1.9 μA +85°C
All devices 0.1 2.0 μA -40°C
V
DD = 5.0V,
(Sleep mode)
0.1 2.0 μA +25°C
0.4 6.5 μA +85°C
Extended devices 11.2 50 μA +125°C
Supply Current (I
DD)
(2,3)
PIC18LF1220/1320 8 40 μA -40°C
F
OSC = 31 kHz
(RC_RUN mode,
Internal oscillator source)
940μA+25°C V
DD = 2.0V
11 40 μA+85°C
PIC18LF1220/1320 25 68 μA -40°C
25 68 μA+25°C V
DD = 3.0V
20 68 μA+85°C
All devices 55 80 μA -40°C
V
DD = 5.0V
55 80 μA+25°C
50 80 μA+85°C
Extended devices 50 80 μA +125°C
Legend: Shading of rows is to assist in readability of the table.
Note 1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD or VSS and all features that add delta
current disabled (such as WDT, Timer1 Oscillator, BOR, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all I
DD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to V
DD;
MCLR
= VDD; WDT enabled/disabled as specified.
3: For RC oscillator configurations, current through R
EXT is not included. The current through the resistor can be estimated
by the formula Ir = V
DD/2REXT (mA) with REXT in kΩ.
4: Standard low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.