Datasheet

 1999-2013 Microchip Technology Inc. DS39026D-page 127
PIC18CXX2
14.3.7 SLEEP OPERATION
In Master mode, all module clocks are halted, and the
transmission/reception will remain in that state until the
device wakes from SLEEP. After the device returns to
normal mode, the module will continue to transmit/
receive data.
In Slave mode, the SPI transmit/receive shift register
operates asynchronously to the device. This allows the
device to be placed in SLEEP mode, and data to be
shifted into the SPI transmit/receive shift register.
When all 8-bits have been received, the MSSP inter-
rupt flag bit will be set and if enabled, will wake the
device from SLEEP.
14.3.8 EFFECTS OF A RESET
A RESET disables the MSSP module and terminates
the current transfer.
14.3.9 BUS MODE COMPATIBILITY
Table 14-1 shows the compatibility between the stan-
dard SPI modes and the states of the CKP and CKE
control bits.
TABLE 14-1: SPI BUS MODES
There is also a SMP bit which controls when the data is
sampled.
TABLE 14-2: REGISTERS ASSOCIATED WITH SPI OPERATION
Standard SPI Mode
Terminology
Control Bits State
CKP CKE
0, 0 0 1
0, 1 0 0
1, 0 1 1
1, 1 1 0
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Value on
POR,
BOR
Value on
all other
RESETS
INTCON GIE/GIEH PEIE/
GIEL
TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF 0000 000x 0000 000u
PIR1
PSPIF
(1)
ADIF RCIF TXIF SSPIF CCP1IF TMR2IF TMR1IF 0000 0000 0000 0000
PIE1
PSPIE
(1)
ADIE RCIE TXIE SSPIE CCP1IE TMR2IE TMR1IE 0000 0000 0000 0000
IPR1
PSPIP
(1)
ADIP RCIP TXIP SSPIP CCP1IP TMR2IP TMR1IP 0000 0000 0000 0000
TRISC PORTC Data Direction Register 1111 1111 1111 1111
SSPBUF Synchronous Serial Port Receive Buffer/Transmit Register xxxx xxxx uuuu uuuu
SSPCON WCOL SSPOV SSPEN CKP SSPM3 SSPM2 SSPM1 SSPM0 0000 0000 0000 0000
TRISA
— PORTA Data Direction Register --11 1111 --11 1111
SSPSTAT SMP CKE
D/A P S R/W UA BF 0000 0000 0000 0000
Legend: x = unknown, u = unchanged, - = unimplemented, read as '0'. Shaded cells are not used by the MSSP in SPI mode.
Note 1: The PSPIF, PSPIE and PSPIP bits are reserved on the PIC18C2X2 devices. Always maintain these bits clear.